There are many advantages to using a fungo bat. If you are a coach or a parent looking to improve your player's defensive skill set, you're going to want and need a fungo bat. A normal adult wooden baseball bat will weigh around 27-31 ounces, and after a couple of rounds of pop-flys, it is going to feel like you just went through a full-on workout. With the help of a fungo bat, you will be able to hit ground balls and pop flys all day without getting fatigued.  The barrel on a fungo bat will typically be 2 1/4 inches in diameter which greatly helps increase your control over the bat through the hitting zone. While the barrel has a much more thin diameter, it is also much longer in comparison to a normal wood baseball bat. This larger hitting surface and smaller barrel combine to give coaches and parents quick swing speeds with precise accuracy. 

Padded support shorts sometimes worn to protect the thighs when the player slides into the bases. Some sliding shorts contain a pocket for a protective cup. This is so the player does not have to wear a jockstrap and sliding shorts at the same time, although many players find the cup is held in place better by wearing it in a jockstrap under sliding shorts.
How the bat is made is what differentiates it from the typical regulation bat used by major league players. In addition to being lighter and thinner, the bat is also much longer compared to the normal bat. It ranges between 35 – 37 inches in terms of length. In terms of weight, the bat weighs between 17 – 22 ounces. Of great importance to note is the fact that the bat features a bigger barrel than the normal ones. Since it’s flatter and features a small diameter, it’s ideal when it comes to hitting ground balls as well as pop flies. This would be necessary during the fielding practice of any team regardless of the level.
Next, third base fungo hits to left, who throw to second, SS cuts (make a few of these the "cut off a double on a ball hit into the corner" variety - timing becomes important here, as the other fungo needs to hit many fewer balls than the fungo hitting to left). First base fungo hits to right, who come home, first baseman is cutoff, 60' from home (about pitchers mound - this postitioning puts him out of harms way should the SS overthrow second). On the throws home from right, make sure that they are the "normal" kind - hit the cutoff man, and don't hit too many. The right fielders will get to go again, as they're last throws will be the "do-or die" variety.
Players can be very particular about their bats. Ted Williams cleaned his bats with alcohol every night and periodically took them to the post office to weigh them. "Bats pick up condensation and dirt lying around on the ground," he wrote, "They can gain an ounce or more in a surprisingly short time." Ichiro Suzuki also takes great care that his bats do not accumulate moisture and thus gain weight: he stores his bats in humidors, one in the club house and another, a portable one, for the road. Rod Carew fought moisture by storing his bats in a box full of sawdust in the warmest part of his house. "The sawdust acts as a buffer between the bats and the environment," he explained, "absorbing any moisture before it can seep into the wood."[25]
To practice throwing around the infield, Bates recommends several drills you can use. The first involves placing four fielders in a square, about 15 feet apart. The players flip the ball underhanded to each other, like in a double play. Keep their arms straight, using a stiff wrist, with gloves on their hips once the ball is out. Every fielder follows their flip, glove side first, rotating around the square. The idea is to have a sequence of catch, flip and follow. The ball should be caught with two hands, palms open. After about two minutes, repeat the process rotating the other way for another two minutes.
As I had previously mentioned, the amount of teaching points is limitless.  The length of the game will really depend on how often you stop the action in order to discuss points related to base running, backing up throws, fielding techniques, and etc.  If you have assistant coaches, have them distributed throughout the field in order to help with certain teaching points on the spot, thus eliminating full stoppages of the game.  Now get out there and start putting the “FUN” back into fungo. I know that’s pretty corny, but I couldn’t help myself 🙂
One of the major advantages of wood fungo has to do with the feel of your hands. While the metal ones feature a conventional metal bat knob, their wood counterparts usually come in 2 knob designs. The conventional metal-bat style knob is excellent for folks whose hands are sweaty. The flared knob is amazing for those that do not want the knob beating their hand’s bottom which is uncomfortable during practice.
The bat's form has become more refined over time. In the mid-19th century, baseball batters were known to shape or whittle their own bats by hand. This allowed there to be a wide variety in shape, size, and weight. For example, there were flat bats, round bats, short bats, and fat bats. Earlier bats were known to be much heavier and larger than today's regulated ones. During the 19th century, many shapes were experimented with, as well as handle designs. Today, bats are much more uniform in design.
The fungo is used by a coach to hit balls for defense practice. It is lighter weight, so less fatiguing to hit ball after ball. The fungo sheds its weight above the hands. The severely tapered barrel to drops weight and maintains a high moment of inertia. While the bat would be at greater risk of breaking if used in a live batting exercise, it is safe to use in practice because there are much fewer mis-hits.
Break your team up into 2 or 3 teams. If you do 2 teams you’ll need 8 or 9 on a team with a player for each defensive position. If you only have 8 on a team you can eliminate either the pitcher, catcher, or one outfielder based on what is a priority for your team that day.  If  you only have 12-15 players on your team break it up into 3 teams of 4-5. Then place two of the teams on defense and one team hitting fungoes. No matter what, have the teams and batting orders pre-made before practice. This will eliminate unnecessary downtime during practice.
Manufacturers position each bat's label over the mechanically weaker side of the wood.[9] To reduce chance of fracture,[9] and maybe deliver more energy to the ball,[10] a bat is intended to be held so the label faces sky or ground when it strikes the ball during a horizontal swing.[9] In this orientation, the bat is considered stiffer and less likely to break.[11]
Break your team up into 2 or 3 teams. If you do 2 teams you’ll need 8 or 9 on a team with a player for each defensive position. If you only have 8 on a team you can eliminate either the pitcher, catcher, or one outfielder based on what is a priority for your team that day.  If  you only have 12-15 players on your team break it up into 3 teams of 4-5. Then place two of the teams on defense and one team hitting fungoes. No matter what, have the teams and batting orders pre-made before practice. This will eliminate unnecessary downtime during practice.
Next, third base fungo hits to left, who throw to second, SS cuts (make a few of these the "cut off a double on a ball hit into the corner" variety - timing becomes important here, as the other fungo needs to hit many fewer balls than the fungo hitting to left). First base fungo hits to right, who come home, first baseman is cutoff, 60' from home (about pitchers mound - this postitioning puts him out of harms way should the SS overthrow second). On the throws home from right, make sure that they are the "normal" kind - hit the cutoff man, and don't hit too many. The right fielders will get to go again, as they're last throws will be the "do-or die" variety.
At bat Baltimore chop Bat flip Chinese home run Batting count Bunt sacrifice bunt slap bunt squeeze play Checked swing Cleanup hitter Designated hitter Double Double switch Foul ball Foul tip Golden sombrero Grand slam Ground rule double Hat trick Hit Hit and run Hit by pitch Hitting for the cycle Home run Infield hit Inside-the-park home run Leadoff hitter Lefty-righty switch Line drive Moonshot Plate appearance Platoon system Pull hitter Sacrifice fly Single Strikeout Strike zone Sweet spot Switch hitter Triple Walk Walk-off home run
Baseball players spend more time training and practicing than playing actual games. You need equipment to take the field during a game, but that equipment won't necessarily prepare you to perform your best out there. Training aids and other baseball practice tools help to grow your game before you take the field so that when you do take that important swing, or field that liner your body and mind are prepared to perform. With batting aids, pitching aids, fielding aids, hitting tees, pitching machines, practice balls, and many more training equipment, Sports Unlimited is able to provide the opportunity to turn any baseball hopeful into a better baseball player. Dreaming it doesn't make it come true, but training hard might.
Baseball players spend more time training and practicing than playing actual games. You need equipment to take the field during a game, but that equipment won't necessarily prepare you to perform your best out there. Training aids and other baseball practice tools help to grow your game before you take the field so that when you do take that important swing, or field that liner your body and mind are prepared to perform. With batting aids, pitching aids, fielding aids, hitting tees, pitching machines, practice balls, and many more training equipment, Sports Unlimited is able to provide the opportunity to turn any baseball hopeful into a better baseball player. Dreaming it doesn't make it come true, but training hard might.
The right baseball equipment can help players pitch, hit, field, and run to the best of their abilities. Whether you’re a coach or a proud parent of an aspiring baseball player, you have come to the right place. Anthem Sports is the most reliable source for coaches, athletic directors, and physical educators that want to set their students and players up for success by investing in the best equipment.
Play It Again Sports® is a registered trademark of Winmark Corporation based in Minneapolis, MN. The Play It Again Sports®, Plato's Closet®, Once Upon A Child®, Music Go Round®, and Style Encore® trademarks and logos utilized in this website are owned by Winmark Corporation and any unauthorized use of these trademarks by others is subject to action under federal and state trademark laws. Other brand names are trademarked or registered by their respective companies.
Padded support shorts sometimes worn to protect the thighs when the player slides into the bases. Some sliding shorts contain a pocket for a protective cup. This is so the player does not have to wear a jockstrap and sliding shorts at the same time, although many players find the cup is held in place better by wearing it in a jockstrap under sliding shorts.
Once the basic bat has been turned, it has the manufacturer's name, the serial number, and often the signature of the player endorsing it branded into it opposite the wood's best side. Honus Wagner was the first player to endorse and sign a bat. Next, most bats are given a rounded head, but some 30%[citation needed] of players prefer a "cup-balanced" head, in which a cup-shaped recess is made in the head; this lightens the bat and moves its center of gravity toward the handle. Finally, the bat is stained in one of several standard colors, including natural, red, black, and two-tone blue and white.
Shirt and pants worn by all players, coaches and managers. Each team generally has a unique pattern of colors and designs. Traditionally, the home team's uniform is predominantly white with the team's nickname, and the visiting team's is predominantly gray with (usually, but not always) the team's city. Teams often have white, gray and colored jerseys; colored jerseys can be worn at home or on the road, depending on the team's preference.

Helmet worn by batter to protect the head and the ear facing the pitcher from the ball. Professional models have only one ear protector (left ear for right-handed batters, right ear for lefties), amateur and junior helmets usually have ear protectors on both sides, for better protection from loose balls, and to reduce costs to teams (all players can use the same style of helmet).
A rounded, solid wooden or hollow aluminum bat. Wooden bats are traditionally made from ash wood, though maple and bamboo is also sometimes used. Aluminum bats are not permitted in professional leagues, but are frequently used in amateur leagues. Composite bats are also available, essentially wooden bats with a metal rod inside. Bamboo bats are also becoming popular.
Break your team up into 2 or 3 teams. If you do 2 teams you’ll need 8 or 9 on a team with a player for each defensive position. If you only have 8 on a team you can eliminate either the pitcher, catcher, or one outfielder based on what is a priority for your team that day.  If  you only have 12-15 players on your team break it up into 3 teams of 4-5. Then place two of the teams on defense and one team hitting fungoes. No matter what, have the teams and batting orders pre-made before practice. This will eliminate unnecessary downtime during practice.
×