The Wright & Ditsons Lajoie baseball bat. This bat had a normal size barrel but had two knobs on the handle. The lowest knob was at the bottom of the handle and the other knob was roughly two inches above the lowest knob. This was designed to have better spacing between the hands due to the knob being in the middle of the grip. This also gave batters an advantage when they choked up on the bat, because the second knob provided a better grip.
Fungo bats aren’t typical bats like the ones Mike Trout takes with him to a game situation. Rather, they’re more of practice bats. The bats are specially made for coaches to utilize when testing the fielding of their players. For example, a coach would break out his or her fungo bat when he or she is looking to hit his or her shortstop a couple of ground balls or when he/she hits pop flies to the centerfielder.
There are limitations to how much and where a baseball player may apply pine tar to a baseball bat. According to Rule 1.10(c) of the Major League Baseball Rulebook, it is not allowed more than 18 inches up from the bottom handle. An infamous example of the rule in execution is the Pine Tar Incident on July 24, 1983. Rules 1.10 and 6.06 were later changed to reflect the intent of Major League Baseball, as exemplified by the league president's ruling. Rule 1.10 now only requires that the bat be removed from the game if discovered after being used in a game; it no longer necessitates any change to the results of any play which may have taken place. Rule 6.06 refers only to bats that are "altered or tampered with in such a way to improve the distance factor or cause an unusual reaction on the baseball. This includes, bats that are filled, flat-surfaced, nailed, hollowed, grooved or covered with a substance such as paraffin, wax, etc." It no longer makes any mention of an "illegally batted ball". In 2001, MLB approved the use of Gorilla Gold Grip Enhancer in major and minor league games as an alternative to pine tar.[23][24]
Do this for about three minutes, then collect the balls and work on 5-3, 6-4, and 4-6 plays for another three minutes. This is followed by hitting balls to the 5-6 hole. If the third baseman doesn’t get it, he retreats back to third, and the shortstop flips to third for a force-out, rather than throwing across or turn a long double play. The other fungo batter hits balls to the second baseman, who works on throwing to first.
Maple bats in particular were once known (circa 2008) to potentially shatter in a way that resulted in many sharp edges, sometimes creating more dangerous projectiles when a bat broke.[9][13] Maple bat manufacture evolved significantly, in cooperation with Major League Baseball,[11] paying special attention to grain slope, and including an ink spot test to confirm safest wood grain orientation.[11]
Many players "bone" their bats, meaning that before games, they rub their bats repeatedly with a hard object, believing this closes the pores on the wood and hardens the bat. Animal bones are a popular boning material, but rolling pins, soda bottles and the edge of a porcelain sink have also been used. Pete Rose had his own way of hardening his bats: he soaked them in a tub of motor oil in his basement then hung them up to dry.[25]

They can either be wood or aluminum. I encourage you to use a wood one. If not, I will make fun of you like I do my good friend Bill Booker at LaSalle-Peru H.S. for using his aluminum one. If you choose the wood fungo, I would recommend taping the barrel.  If you hit a good number of fungoes, the tape will increase the durability of the bat. I took the tape off of one once. The barrell was like sawdust, but I re-taped it and it was ready to go.  One season, I figured it out, between the  high school, American Legion, an junior high seasons I had hit over 10,000 fungoes. Tape it up!

Fungo bats are, simply put, a long, skinny, and lightweight baseball bat used for fielding practice. Typically, they are around 34 to 37 inches in length and between 17 and 24 ounces in weight, give or take a couple of ounces. They will also almost always feature a 2 1/4 inch barrel diameter to allow for more control during a swing. As you can tell, fungo bats are longer than a normal baseball bat and much more lightweight in comparison. Most fungo bats are going to be made up of ash wood while there are some maple and bamboo wood fungo bats, some composite wood fungo bats, and very few aluminum alloy fungo bats. Almost all of these designs will be under $100 with very few eclipsing that mark. 

First base fungo hits fly balls to center field (helps here if both fungo hitters move up and apart, hitting from about the front of the mound extended towards the bases). Center throws to second, second baseman is cutoff (for us it was, anyways - change to suit your style). Third base fungo hits balls to left field, who throw to third, with a second shortstop as cutoff (but you really don't need one, if you're shorthanded).
When it comes to baseball gloves, it's not uncommon for players to develop a deep attachment to their glove. It's the same glove they trot out onto the field with every inning and many players, once they are into the 'adult' sizes, use the same glove for their entire life! It might seem crazy to outsiders, but there's just something about a high quality, leather baseball glove that becomes part of a player to the point that it feels wrong to wear a different glove. That is why it is so important to find the right glove, the right pocket, the right size, the right leather, and the right color. Gloves aren't just gloves, they are part of who you become as a player. Check out our selection of gloves by position, size, and brand or explore the buying guide specifically made to help you decide which baseball glove to buy if you need some guidance!
Players can also create complex holes such as ‘two-part holes’ where the players must hit or reach one object before attempting to shoot at the hole. For example, a ‘two-part hole’ could consist of hitting the scoreboard first, and then once they have hit the scoreboard they must hit the ball back to home plate, that would be one hole with the player with the fewest strokes winning the hole. ‘Two-part holes’ are typically saved for the last hole in order to make things more complex and difficult on the leader.