The bat's form has become more refined over time. In the mid-19th century, baseball batters were known to shape or whittle their own bats by hand. This allowed there to be a wide variety in shape, size, and weight. For example, there were flat bats, round bats, short bats, and fat bats. Earlier bats were known to be much heavier and larger than today's regulated ones. During the 19th century, many shapes were experimented with, as well as handle designs. Today, bats are much more uniform in design.
Baseball bats are made of either wood, or a metal alloy (typically aluminum). Most wooden bats are made from ash. Other woods include maple, hickory, and bamboo. Hickory has fallen into disfavor over its greater weight, which slows down bat speed, while maple bats gained popularity following the introduction of the first major league sanctioned model in 1997. The first player to use one was Joe Carter of the Toronto Blue Jays. Barry Bonds used maple bats the seasons he broke baseball's single-season home run record in 2001, and the career home run record in 2007. In 2010, the increased tendency of maple bats to shatter has caused Major League Baseball to examine their use, banning some models in minor league play.
A baseball bat is divided into several regions. The "barrel" is the thick part of the bat, where it is meant to hit the ball. The part of the barrel best for hitting the ball, according to construction and swinging style, is often called the "sweet spot". The end of the barrel is called the "top", "end" or "cap" of the bat. Opposite the cap, the barrel narrows until it meets the "handle". The handle is comparatively thin, so that batters can comfortably grip the bat in their hands. Sometimes, especially on metal bats, the handle is wrapped with a rubber or tape "grip". Finally, below the handle is the "knob" of the bat, a wider piece that keeps the bat from slipping from a batter's hands.
They can either be wood or aluminum. I encourage you to use a wood one. If not, I will make fun of you like I do my good friend Bill Booker at LaSalle-Peru H.S. for using his aluminum one. If you choose the wood fungo, I would recommend taping the barrel. If you hit a good number of fungoes, the tape will increase the durability of the bat. I took the tape off of one once. The barrell was like sawdust, but I re-taped it and it was ready to go. One season, I figured it out, between the high school, American Legion, an junior high seasons I had hit over 10,000 fungoes. Tape it up!
To figure out who shoots first, players usually throw or roll a baseball to a certain object (usually at close range) and whoever is closest shoots first. The first person then gets to choose the first hole and tees off. To tee off (and for most shots) players hit the ball like they were playing baseball, but depending on the distance from the hole the player may choose to ‘putt’ the ball instead of hitting it. To putt the ball, the player places the ball on the cup (the end of the fungo bat), and can toss the ball from the cup in hopes of getting a more accurate shot. In shooting or putting, the player must have one foot where the ball landed during the entire duration of their swing or putt, failure to keep the foot planted results in a loss of a stroke. Scorekeeping is identical to traditional golf; the player with the fewest strokes essentially wins the hole. Players traditionally play nine or eighteen holes of fungo golf, and at the end the person with the fewest strokes in the set number of holes wins the game.