There are limitations to how much and where a baseball player may apply pine tar to a baseball bat. According to Rule 1.10(c) of the Major League Baseball Rulebook, it is not allowed more than 18 inches up from the bottom handle. An infamous example of the rule in execution is the Pine Tar Incident on July 24, 1983. Rules 1.10 and 6.06 were later changed to reflect the intent of Major League Baseball, as exemplified by the league president's ruling. Rule 1.10 now only requires that the bat be removed from the game if discovered after being used in a game; it no longer necessitates any change to the results of any play which may have taken place. Rule 6.06 refers only to bats that are "altered or tampered with in such a way to improve the distance factor or cause an unusual reaction on the baseball. This includes, bats that are filled, flat-surfaced, nailed, hollowed, grooved or covered with a substance such as paraffin, wax, etc." It no longer makes any mention of an "illegally batted ball". In 2001, MLB approved the use of Gorilla Gold Grip Enhancer in major and minor league games as an alternative to pine tar.[23][24]
A baseball bat is divided into several regions. The "barrel" is the thick part of the bat, where it is meant to hit the ball. The part of the barrel best for hitting the ball, according to construction and swinging style, is often called the "sweet spot". The end of the barrel is called the "top", "end" or "cap" of the bat. Opposite the cap, the barrel narrows until it meets the "handle". The handle is comparatively thin, so that batters can comfortably grip the bat in their hands. Sometimes, especially on metal bats, the handle is wrapped with a rubber or tape "grip". Finally, below the handle is the "knob" of the bat, a wider piece that keeps the bat from slipping from a batter's hands.
This sounds like a lot of information, but with a little practise on the coaches part, it runs quite smoothly. Two to three reps per player in the field per section is quite adequate, and with 14 men on the field, this whole routine should take about 7 minutes. It's quite snappy, and quite impressive. I had many a parent marvel to me after witnessing it - "you look like a professional team!" I wouldn't try the routine with anything less than a 14 yr old select team, but with the talent to do it right, it's fantastic.
Fungo bats typically weigh between 17 to 22 ounces and may be as long as 37 inches, making them longer than most bats used for hitting. According to Pro Bats, a typical professional baseball player uses a bat that is about 34 inches long and weighs about 32 ounces, although there is considerable variation. Fungo bats not only are longer than regular bats, they also are skinnier. Like regular bats, fungo bats can be made of metal or wood.
To figure out who shoots first, players usually throw or roll a baseball to a certain object (usually at close range) and whoever is closest shoots first. The first person then gets to choose the first hole and tees off. To tee off (and for most shots) players hit the ball like they were playing baseball, but depending on the distance from the hole the player may choose to ‘putt’ the ball instead of hitting it. To putt the ball, the player places the ball on the cup (the end of the fungo bat), and can toss the ball from the cup in hopes of getting a more accurate shot.[1] In shooting or putting, the player must have one foot where the ball landed during the entire duration of their swing or putt, failure to keep the foot planted results in a loss of a stroke. Scorekeeping is identical to traditional golf; the player with the fewest strokes essentially wins the hole.[2] Players traditionally play nine or eighteen holes of fungo golf, and at the end the person with the fewest strokes in the set number of holes wins the game.[3]
×