There are limitations to how much and where a baseball player may apply pine tar to a baseball bat. According to Rule 1.10(c) of the Major League Baseball Rulebook, it is not allowed more than 18 inches up from the bottom handle. An infamous example of the rule in execution is the Pine Tar Incident on July 24, 1983. Rules 1.10 and 6.06 were later changed to reflect the intent of Major League Baseball, as exemplified by the league president's ruling. Rule 1.10 now only requires that the bat be removed from the game if discovered after being used in a game; it no longer necessitates any change to the results of any play which may have taken place. Rule 6.06 refers only to bats that are "altered or tampered with in such a way to improve the distance factor or cause an unusual reaction on the baseball. This includes, bats that are filled, flat-surfaced, nailed, hollowed, grooved or covered with a substance such as paraffin, wax, etc." It no longer makes any mention of an "illegally batted ball". In 2001, MLB approved the use of Gorilla Gold Grip Enhancer in major and minor league games as an alternative to pine tar.
Fungo bats are typically only used by coaches, to consistently place grounders and pop flies to their fielders for practice purposes. And with a fungo bat in their hands, some coaches can pull off wicked accuracy – as one story goes, the late California Angels player and coach Jimmie Reese once shot an 82 on an 18-hole golf course using nothing but a putter and a fungo bat.
Fungo bats are, simply put, a long, skinny, and lightweight baseball bat used for fielding practice. Typically, they are around 34 to 37 inches in length and between 17 and 24 ounces in weight, give or take a couple of ounces. They will also almost always feature a 2 1/4 inch barrel diameter to allow for more control during a swing. As you can tell, fungo bats are longer than a normal baseball bat and much more lightweight in comparison. Most fungo bats are going to be made up of ash wood while there are some maple and bamboo wood fungo bats, some composite wood fungo bats, and very few aluminum alloy fungo bats. Almost all of these designs will be under $100 with very few eclipsing that mark.
Secondly, the first base fungo hits balls to the third baseman, who turns a double play with the second baseman to the normal first baseman, while the third base fungo hits balls to the shortstop, who throws to a shortened deep firstbaseman (this means that the deep firstbaseman stands closer to the shortstop than normal, so that the throw across this infield is the correct distance - this does NOT mean that the deep man stands any closer to the normal first base position - this length should always be sufficient)
Do this for about three minutes, then collect the balls and work on 5-3, 6-4, and 4-6 plays for another three minutes. This is followed by hitting balls to the 5-6 hole. If the third baseman doesn’t get it, he retreats back to third, and the shortstop flips to third for a force-out, rather than throwing across or turn a long double play. The other fungo batter hits balls to the second baseman, who works on throwing to first.
Baseball bats are made of either wood, or a metal alloy (typically aluminum). Most wooden bats are made from ash. Other woods include maple, hickory, and bamboo. Hickory has fallen into disfavor over its greater weight, which slows down bat speed, while maple bats gained popularity following the introduction of the first major league sanctioned model in 1997. The first player to use one was Joe Carter of the Toronto Blue Jays. Barry Bonds used maple bats the seasons he broke baseball's single-season home run record in 2001, and the career home run record in 2007. In 2010, the increased tendency of maple bats to shatter has caused Major League Baseball to examine their use, banning some models in minor league play.
Players can also create complex holes such as ‘two-part holes’ where the players must hit or reach one object before attempting to shoot at the hole. For example, a ‘two-part hole’ could consist of hitting the scoreboard first, and then once they have hit the scoreboard they must hit the ball back to home plate, that would be one hole with the player with the fewest strokes winning the hole. ‘Two-part holes’ are typically saved for the last hole in order to make things more complex and difficult on the leader.