To practice throwing around the infield, Bates recommends several drills you can use. The first involves placing four fielders in a square, about 15 feet apart. The players flip the ball underhanded to each other, like in a double play. Keep their arms straight, using a stiff wrist, with gloves on their hips once the ball is out. Every fielder follows their flip, glove side first, rotating around the square. The idea is to have a sequence of catch, flip and follow. The ball should be caught with two hands, palms open. After about two minutes, repeat the process rotating the other way for another two minutes.
If you have attended a Major League Baseball game in the last 15 years, pregame infield practice, known simply as infield, may be unfamiliar. All but abandoned by the early 2000s, the ritual lives on at the C.W.S. and at college stadiums all over the country. On Monday night, the routine will be repeated before Virginia takes on Vanderbilt in the first game of the finals.
Once in a while, veteran managers revive it. The Giants took infield occasionally in 2008 and 2013 under Bruce Bochy, and Jim Leyland instituted infield drills before batting practice late in his tenure in Detroit. Molitor, for one, misses it. He took infield even as a designated hitter late in his career because he hated sitting around for almost two hours waiting to play.
Catcher's equipment - A catcher is the target for the pitcher, so the catcher must wear protective gear that covers the majority of his body. Catcher's gear includes a helmet with a faceguard that is similar to a hockey goalie's mask, a chest protector, shin guards, and a special padded glove. Some catcher's also wear devices called knee savers, which are triangular pads that attach to the players calves and rest his knees even while squatting behind the plate.
They can either be wood or aluminum. I encourage you to use a wood one. If not, I will make fun of you like I do my good friend Bill Booker at LaSalle-Peru H.S. for using his aluminum one. If you choose the wood fungo, I would recommend taping the barrel. If you hit a good number of fungoes, the tape will increase the durability of the bat. I took the tape off of one once. The barrell was like sawdust, but I re-taped it and it was ready to go. One season, I figured it out, between the high school, American Legion, an junior high seasons I had hit over 10,000 fungoes. Tape it up!
At bat Baltimore chop Bat flip Chinese home run Batting count Bunt sacrifice bunt slap bunt squeeze play Checked swing Cleanup hitter Designated hitter Double Double switch Foul ball Foul tip Golden sombrero Grand slam Ground rule double Hat trick Hit Hit and run Hit by pitch Hitting for the cycle Home run Infield hit Inside-the-park home run Leadoff hitter Lefty-righty switch Line drive Moonshot Plate appearance Platoon system Pull hitter Sacrifice fly Single Strikeout Strike zone Sweet spot Switch hitter Triple Walk Walk-off home run
A baseball bat is divided into several regions. The "barrel" is the thick part of the bat, where it is meant to hit the ball. The part of the barrel best for hitting the ball, according to construction and swinging style, is often called the "sweet spot". The end of the barrel is called the "top", "end" or "cap" of the bat. Opposite the cap, the barrel narrows until it meets the "handle". The handle is comparatively thin, so that batters can comfortably grip the bat in their hands. Sometimes, especially on metal bats, the handle is wrapped with a rubber or tape "grip". Finally, below the handle is the "knob" of the bat, a wider piece that keeps the bat from slipping from a batter's hands.
Fungo bats are typically only used by coaches, to consistently place grounders and pop flies to their fielders for practice purposes. And with a fungo bat in their hands, some coaches can pull off wicked accuracy – as one story goes, the late California Angels player and coach Jimmie Reese once shot an 82 on an 18-hole golf course using nothing but a putter and a fungo bat.