A baseball bat is divided into several regions. The "barrel" is the thick part of the bat, where it is meant to hit the ball. The part of the barrel best for hitting the ball, according to construction and swinging style, is often called the "sweet spot". The end of the barrel is called the "top", "end" or "cap" of the bat. Opposite the cap, the barrel narrows until it meets the "handle". The handle is comparatively thin, so that batters can comfortably grip the bat in their hands. Sometimes, especially on metal bats, the handle is wrapped with a rubber or tape "grip". Finally, below the handle is the "knob" of the bat, a wider piece that keeps the bat from slipping from a batter's hands.
Next, third base fungo hits to left, who throw to second, SS cuts (make a few of these the "cut off a double on a ball hit into the corner" variety - timing becomes important here, as the other fungo needs to hit many fewer balls than the fungo hitting to left). First base fungo hits to right, who come home, first baseman is cutoff, 60' from home (about pitchers mound - this postitioning puts him out of harms way should the SS overthrow second). On the throws home from right, make sure that they are the "normal" kind - hit the cutoff man, and don't hit too many. The right fielders will get to go again, as they're last throws will be the "do-or die" variety.
Maple bats in particular were once known (circa 2008) to potentially shatter in a way that resulted in many sharp edges, sometimes creating more dangerous projectiles when a bat broke. Maple bat manufacture evolved significantly, in cooperation with Major League Baseball, paying special attention to grain slope, and including an ink spot test to confirm safest wood grain orientation.