If you care about getting the best baseball gear at the best price then you have come to the right place. Better Baseball stocks the full line of baseball bats, baseball gloves, batting gloves, baseball helmets, baseballs, field equipment, batting cages, protective screens, catcher's gear and more, at great prices, and we ship them directly to you faster than anyone else.
As to who created the first ever fungo, baseball fans may never know. The word fungoes and fungo batting have been referenced since the early 1800's, but nobody has been able to pinpoint the original source. Baseball fans and historians both agree that the creator of the first ever fungo is somewhat of a mystery. Here at JustBats, we may not know who created the first ever fungo, but we are sure glad that they did!
Manufacturers position each bat's label over the mechanically weaker side of the wood. To reduce chance of fracture, and maybe deliver more energy to the ball, a bat is intended to be held so the label faces sky or ground when it strikes the ball during a horizontal swing. In this orientation, the bat is considered stiffer and less likely to break.
They can either be wood or aluminum. I encourage you to use a wood one. If not, I will make fun of you like I do my good friend Bill Booker at LaSalle-Peru H.S. for using his aluminum one. If you choose the wood fungo, I would recommend taping the barrel. If you hit a good number of fungoes, the tape will increase the durability of the bat. I took the tape off of one once. The barrell was like sawdust, but I re-taped it and it was ready to go. One season, I figured it out, between the high school, American Legion, an junior high seasons I had hit over 10,000 fungoes. Tape it up!
A baseball bat is divided into several regions. The "barrel" is the thick part of the bat, where it is meant to hit the ball. The part of the barrel best for hitting the ball, according to construction and swinging style, is often called the "sweet spot". The end of the barrel is called the "top", "end" or "cap" of the bat. Opposite the cap, the barrel narrows until it meets the "handle". The handle is comparatively thin, so that batters can comfortably grip the bat in their hands. Sometimes, especially on metal bats, the handle is wrapped with a rubber or tape "grip". Finally, below the handle is the "knob" of the bat, a wider piece that keeps the bat from slipping from a batter's hands.
The Wright & Ditsons Lajoie baseball bat. This bat had a normal size barrel but had two knobs on the handle. The lowest knob was at the bottom of the handle and the other knob was roughly two inches above the lowest knob. This was designed to have better spacing between the hands due to the knob being in the middle of the grip. This also gave batters an advantage when they choked up on the bat, because the second knob provided a better grip.
This sounds like a lot of information, but with a little practise on the coaches part, it runs quite smoothly. Two to three reps per player in the field per section is quite adequate, and with 14 men on the field, this whole routine should take about 7 minutes. It's quite snappy, and quite impressive. I had many a parent marvel to me after witnessing it - "you look like a professional team!" I wouldn't try the routine with anything less than a 14 yr old select team, but with the talent to do it right, it's fantastic.
Next, third base fungo hits to left, who throw to second, SS cuts (make a few of these the "cut off a double on a ball hit into the corner" variety - timing becomes important here, as the other fungo needs to hit many fewer balls than the fungo hitting to left). First base fungo hits to right, who come home, first baseman is cutoff, 60' from home (about pitchers mound - this postitioning puts him out of harms way should the SS overthrow second). On the throws home from right, make sure that they are the "normal" kind - hit the cutoff man, and don't hit too many. The right fielders will get to go again, as they're last throws will be the "do-or die" variety.