Fungo bats are, simply put, a long, skinny, and lightweight baseball bat used for fielding practice. Typically, they are around 34 to 37 inches in length and between 17 and 24 ounces in weight, give or take a couple of ounces. They will also almost always feature a 2 1/4 inch barrel diameter to allow for more control during a swing. As you can tell, fungo bats are longer than a normal baseball bat and much more lightweight in comparison. Most fungo bats are going to be made up of ash wood while there are some maple and bamboo wood fungo bats, some composite wood fungo bats, and very few aluminum alloy fungo bats. Almost all of these designs will be under $100 with very few eclipsing that mark. 

A baseball bat is divided into several regions. The "barrel" is the thick part of the bat, where it is meant to hit the ball. The part of the barrel best for hitting the ball, according to construction and swinging style, is often called the "sweet spot". The end of the barrel is called the "top", "end" or "cap" of the bat. Opposite the cap, the barrel narrows until it meets the "handle". The handle is comparatively thin, so that batters can comfortably grip the bat in their hands. Sometimes, especially on metal bats, the handle is wrapped with a rubber or tape "grip". Finally, below the handle is the "knob" of the bat, a wider piece that keeps the bat from slipping from a batter's hands.
A fungo bat is used by the coach to hit ground balls or fly balls to his team. All throughout high school and college many players use fungo bats to play fungo golf. This is when each person has a fungo bat and a baseball and they pick out targets around their field or complex and basically play it in the same manner as golf. Fungo bats should not be used to hit a pitched baseball because they are much weaker than normal bats and will break much much easier.

At bat Baltimore chop Bat flip Chinese home run Batting count Bunt sacrifice bunt slap bunt squeeze play Checked swing Cleanup hitter Designated hitter Double Double switch Foul ball Foul tip Golden sombrero Grand slam Ground rule double Hat trick Hit Hit and run Hit by pitch Hitting for the cycle Home run Infield hit Inside-the-park home run Leadoff hitter Lefty-righty switch Line drive Moonshot Plate appearance Platoon system Pull hitter Sacrifice fly Single Strikeout Strike zone Sweet spot Switch hitter Triple Walk Walk-off home run
It is not clear why pregame infield fell out of favor in the majors. Today, coaches hit balls to infielders and outfielders during batting practice. Most players go at it leisurely, lobbing balls back in or across the diamond. That rankles old-school players like Jerry Kindall, a former major league infielder who coached Arizona to three N.C.A.A. titles before retiring in 1996.
Baseball bats are made of either wood, or a metal alloy (typically aluminum). Most wooden bats are made from ash. Other woods include maple, hickory, and bamboo. Hickory has fallen into disfavor over its greater weight, which slows down bat speed, while maple bats gained popularity[5] following the introduction of the first major league sanctioned model in 1997. The first player to use one was Joe Carter of the Toronto Blue Jays.[6] Barry Bonds used maple bats the seasons he broke baseball's single-season home run record in 2001, and the career home run record in 2007.[6] In 2010, the increased tendency of maple bats to shatter has caused Major League Baseball to examine their use, banning some models in minor league play.[7][8]
Another variation of playing is setting a target (i.e. home plate), and that is the hole for the entire game. For the entire game players go to a different part of the field and try to hit home plate in the fewest strokes.To make the game more interesting players can create certain hazards or obstacles that the players must avoid hitting while making their shot. If a player hits a certain hazard then they may be penalized one stroke, a player can also lose a stroke if he loses their ball while taking a shot.
×