At bat Baltimore chop Bat flip Chinese home run Batting count Bunt sacrifice bunt slap bunt squeeze play Checked swing Cleanup hitter Designated hitter Double Double switch Foul ball Foul tip Golden sombrero Grand slam Ground rule double Hat trick Hit Hit and run Hit by pitch Hitting for the cycle Home run Infield hit Inside-the-park home run Leadoff hitter Lefty-righty switch Line drive Moonshot Plate appearance Platoon system Pull hitter Sacrifice fly Single Strikeout Strike zone Sweet spot Switch hitter Triple Walk Walk-off home run
If your high school or travel team has at least two coaches, you can use what Bates calls a two-fungo drill. One coach can hit to third and second, while the other hits to short and first. If catchers are finished working with the pitchers, they can feed balls to the fungo hitters. The idea is for the third baseman to practice turning a 5-4-3, with the first baseman moving up toward second base about 60 feet instead of 90, with a net behind him to catch overthrows. The shortstop works on throwing across on 6-3s.
Maple bats in particular were once known (circa 2008) to potentially shatter in a way that resulted in many sharp edges, sometimes creating more dangerous projectiles when a bat broke.[9][13] Maple bat manufacture evolved significantly, in cooperation with Major League Baseball,[11] paying special attention to grain slope, and including an ink spot test to confirm safest wood grain orientation.[11]
Players can be very particular about their bats. Ted Williams cleaned his bats with alcohol every night and periodically took them to the post office to weigh them. "Bats pick up condensation and dirt lying around on the ground," he wrote, "They can gain an ounce or more in a surprisingly short time." Ichiro Suzuki also takes great care that his bats do not accumulate moisture and thus gain weight: he stores his bats in humidors, one in the club house and another, a portable one, for the road. Rod Carew fought moisture by storing his bats in a box full of sawdust in the warmest part of his house. "The sawdust acts as a buffer between the bats and the environment," he explained, "absorbing any moisture before it can seep into the wood."[25]
The most obvious reasons to utilize a fungo bat is the fact that it’s lightweight. It’s handy to coaches when conducting fielding practice since he or she has to hit plenty of balls to warm up his or her players. What is for sure is that hitting countless balls during practice can be tiring. Consequently, having a bat that’s lighter weight is magical at preventing the coach and/or players from getting tired.

A fungo bat is used by the coach to hit ground balls or fly balls to his team. All throughout high school and college many players use fungo bats to play fungo golf. This is when each person has a fungo bat and a baseball and they pick out targets around their field or complex and basically play it in the same manner as golf. Fungo bats should not be used to hit a pitched baseball because they are much weaker than normal bats and will break much much easier.
Whether you’re looking for youth league or adult league solutions, our selection of baseball gear offers everything you need to kick off the baseball season with your best foot forward. We carry nothing but the finest baseball mitts and gloves available made by Wilson®, Mizuno®, Louisville®, and other brands trusted by professional baseball players and coaches. Carry your gear to the diamond with ease with the help of our sleek and stylish backpacks, equipment bags, and duffels.
Helmet worn by batter to protect the head and the ear facing the pitcher from the ball. Professional models have only one ear protector (left ear for right-handed batters, right ear for lefties), amateur and junior helmets usually have ear protectors on both sides, for better protection from loose balls, and to reduce costs to teams (all players can use the same style of helmet).

Baseball bats are made of either wood, or a metal alloy (typically aluminum). Most wooden bats are made from ash. Other woods include maple, hickory, and bamboo. Hickory has fallen into disfavor over its greater weight, which slows down bat speed, while maple bats gained popularity[5] following the introduction of the first major league sanctioned model in 1997. The first player to use one was Joe Carter of the Toronto Blue Jays.[6] Barry Bonds used maple bats the seasons he broke baseball's single-season home run record in 2001, and the career home run record in 2007.[6] In 2010, the increased tendency of maple bats to shatter has caused Major League Baseball to examine their use, banning some models in minor league play.[7][8]


Padded support shorts sometimes worn to protect the thighs when the player slides into the bases. Some sliding shorts contain a pocket for a protective cup. This is so the player does not have to wear a jockstrap and sliding shorts at the same time, although many players find the cup is held in place better by wearing it in a jockstrap under sliding shorts.

Break your team up into 2 or 3 teams. If you do 2 teams you’ll need 8 or 9 on a team with a player for each defensive position. If you only have 8 on a team you can eliminate either the pitcher, catcher, or one outfielder based on what is a priority for your team that day.  If  you only have 12-15 players on your team break it up into 3 teams of 4-5. Then place two of the teams on defense and one team hitting fungoes. No matter what, have the teams and batting orders pre-made before practice. This will eliminate unnecessary downtime during practice.
Baseball bats are made of either wood, or a metal alloy (typically aluminum). Most wooden bats are made from ash. Other woods include maple, hickory, and bamboo. Hickory has fallen into disfavor over its greater weight, which slows down bat speed, while maple bats gained popularity[5] following the introduction of the first major league sanctioned model in 1997. The first player to use one was Joe Carter of the Toronto Blue Jays.[6] Barry Bonds used maple bats the seasons he broke baseball's single-season home run record in 2001, and the career home run record in 2007.[6] In 2010, the increased tendency of maple bats to shatter has caused Major League Baseball to examine their use, banning some models in minor league play.[7][8]
Within league standards there is ample latitude for individual variation, many batters settling on their own bat profile, or one used by a successful batter. Formerly, bats were hand-turned from a template with precise calibration points; today they are machine-turned to a fixed metal template. Historically significant templates may be kept in a bat manufacturers' vault; for example, Babe Ruth's template, which became popular among major-league players, is R43 in the Louisville Slugger archives.[citation needed]
Chris Coste, a former catcher for the Philadelphia Phillies who coaches at Division III Concordia, in Moorhead, Minn., agreed. “When baseball is every single day, you’ve got to do things differently,” he said. “In the big leagues, they get so many ground balls during batting practice that infield is more for the fans and more for the scouts and things like that. At this level, we need it, and we love doing it.”
No, we're not talking about The Masters. We're talking about fungo golf, baseball's wonderful adaptation of frisbee golf. For those of you unfamiliar with the rules, the general goal is to hit predetermined objects or other landmarks located somewhere on a baseball field with a ball. Instead of a golf club, you use a fungo bat. All normal scoring rules of golf still apply.

Catcher's equipment - A catcher is the target for the pitcher, so the catcher must wear protective gear that covers the majority of his body. Catcher's gear includes a helmet with a faceguard that is similar to a hockey goalie's mask, a chest protector, shin guards, and a special padded glove. Some catcher's also wear devices called knee savers, which are triangular pads that attach to the players calves and rest his knees even while squatting behind the plate.
Both wooden and metal alloy (generally aluminum) bats are generally permitted in amateur baseball. Metal alloy bats are generally regarded as being capable of hitting a ball faster and farther with the same power. However, increasing numbers of "wooden bat leagues" have emerged in recent years, reflecting a trend back to wood over safety concerns and, in the case of collegiate summer baseball wood-bat leagues, to better prepare players for the professional leagues that require wood bats. Metal alloy bats can send a ball towards an unprotected pitcher's head up to 60 ft 6 in (18.44 m) away at a velocity far too high for the pitcher to get out of the way in time. Some amateur baseball organizations enforce bat manufacturing and testing standards which attempt to limit maximum ball speed for wood and non-wood bats.[17][18][19]
As to who created the first ever fungo, baseball fans may never know. The word fungoes and fungo batting have been referenced since the early 1800's, but nobody has been able to pinpoint the original source. Baseball fans and historians both agree that the creator of the first ever fungo is somewhat of a mystery. Here at JustBats, we may not know who created the first ever fungo, but we are sure glad that they did!
×