A baseball bat is divided into several regions. The "barrel" is the thick part of the bat, where it is meant to hit the ball. The part of the barrel best for hitting the ball, according to construction and swinging style, is often called the "sweet spot". The end of the barrel is called the "top", "end" or "cap" of the bat. Opposite the cap, the barrel narrows until it meets the "handle". The handle is comparatively thin, so that batters can comfortably grip the bat in their hands. Sometimes, especially on metal bats, the handle is wrapped with a rubber or tape "grip". Finally, below the handle is the "knob" of the bat, a wider piece that keeps the bat from slipping from a batter's hands.

When it comes to baseball gloves, it's not uncommon for players to develop a deep attachment to their glove. It's the same glove they trot out onto the field with every inning and many players, once they are into the 'adult' sizes, use the same glove for their entire life! It might seem crazy to outsiders, but there's just something about a high quality, leather baseball glove that becomes part of a player to the point that it feels wrong to wear a different glove. That is why it is so important to find the right glove, the right pocket, the right size, the right leather, and the right color. Gloves aren't just gloves, they are part of who you become as a player. Check out our selection of gloves by position, size, and brand or explore the buying guide specifically made to help you decide which baseball glove to buy if you need some guidance!


A fungo bat is a specially designed bat used by baseball and softball coaches for practice. The etymology of the word fungo ( /ˈfʌŋɡoʊ/) is uncertain, but the Oxford English Dictionary suggests it is derived from the Scots fung: to pitch, toss, or fling.[26] A fungo is longer and lighter than a regulation bat, with a smaller diameter. The bat is designed to hit balls tossed up in the air by the batter, not pitched balls.[27] Typical fungo bats are 35 to 37 inches (89 to 94 cm) long and weigh 17 to 22 ounces (480 to 620 g). Coaches hit many balls during fielding practice, and the weight and length allow the coach to hit balls repeatedly with high accuracy. The small diameter also allows coaches to easily hit pop-ups to catchers and infielders along with ground balls due to better control of the barrel of the bat.
This sounds like a lot of information, but with a little practise on the coaches part, it runs quite smoothly. Two to three reps per player in the field per section is quite adequate, and with 14 men on the field, this whole routine should take about 7 minutes. It's quite snappy, and quite impressive. I had many a parent marvel to me after witnessing it - "you look like a professional team!" I wouldn't try the routine with anything less than a 14 yr old select team, but with the talent to do it right, it's fantastic.
Maple bats in particular were once known (circa 2008) to potentially shatter in a way that resulted in many sharp edges, sometimes creating more dangerous projectiles when a bat broke.[9][13] Maple bat manufacture evolved significantly, in cooperation with Major League Baseball,[11] paying special attention to grain slope, and including an ink spot test to confirm safest wood grain orientation.[11]
Do this for about three minutes, then collect the balls and work on 5-3, 6-4, and 4-6 plays for another three minutes. This is followed by hitting balls to the 5-6 hole. If the third baseman doesn’t get it, he retreats back to third, and the shortstop flips to third for a force-out, rather than throwing across or turn a long double play. The other fungo batter hits balls to the second baseman, who works on throwing to first.
The Wright & Ditsons Lajoie baseball bat. This bat had a normal size barrel but had two knobs on the handle. The lowest knob was at the bottom of the handle and the other knob was roughly two inches above the lowest knob. This was designed to have better spacing between the hands due to the knob being in the middle of the grip. This also gave batters an advantage when they choked up on the bat, because the second knob provided a better grip.

Baseball bats are made of either wood, or a metal alloy (typically aluminum). Most wooden bats are made from ash. Other woods include maple, hickory, and bamboo. Hickory has fallen into disfavor over its greater weight, which slows down bat speed, while maple bats gained popularity[5] following the introduction of the first major league sanctioned model in 1997. The first player to use one was Joe Carter of the Toronto Blue Jays.[6] Barry Bonds used maple bats the seasons he broke baseball's single-season home run record in 2001, and the career home run record in 2007.[6] In 2010, the increased tendency of maple bats to shatter has caused Major League Baseball to examine their use, banning some models in minor league play.[7][8]
Even in those formative years, authorities on the game warned the practice of hitting fungoes should be limited to coaches. Henry Chadwick, one of baseball’s earliest proponents, claimed “The weakest batting is shown when the batsmen indulges in fungo hitting,” according to the Art of Batting. Others agreed that the practice was bad for training a batter’s reflexes: “While watching some of our freshmen practicing ‘fungo’ batting the other afternoon it occurred to me that it was about the worst kind of practice a batsman could imagine in training his eye in batting,” a writer claimed in the March 3, 1886 edition of The Sporting Life. “It trains the eye to meet the ball in batting it in a manner which never occurs in actual play. It ought to be prohibited on every well regulated ball field.”
×