At bat Baltimore chop Bat flip Chinese home run Batting count Bunt sacrifice bunt slap bunt squeeze play Checked swing Cleanup hitter Designated hitter Double Double switch Foul ball Foul tip Golden sombrero Grand slam Ground rule double Hat trick Hit Hit and run Hit by pitch Hitting for the cycle Home run Infield hit Inside-the-park home run Leadoff hitter Lefty-righty switch Line drive Moonshot Plate appearance Platoon system Pull hitter Sacrifice fly Single Strikeout Strike zone Sweet spot Switch hitter Triple Walk Walk-off home run
They can either be wood or aluminum. I encourage you to use a wood one. If not, I will make fun of you like I do my good friend Bill Booker at LaSalle-Peru H.S. for using his aluminum one. If you choose the wood fungo, I would recommend taping the barrel.  If you hit a good number of fungoes, the tape will increase the durability of the bat. I took the tape off of one once. The barrell was like sawdust, but I re-taped it and it was ready to go.  One season, I figured it out, between the  high school, American Legion, an junior high seasons I had hit over 10,000 fungoes. Tape it up!
The Wright & Ditsons Lajoie baseball bat. This bat had a normal size barrel but had two knobs on the handle. The lowest knob was at the bottom of the handle and the other knob was roughly two inches above the lowest knob. This was designed to have better spacing between the hands due to the knob being in the middle of the grip. This also gave batters an advantage when they choked up on the bat, because the second knob provided a better grip.
A baseball bat is divided into several regions. The "barrel" is the thick part of the bat, where it is meant to hit the ball. The part of the barrel best for hitting the ball, according to construction and swinging style, is often called the "sweet spot". The end of the barrel is called the "top", "end" or "cap" of the bat. Opposite the cap, the barrel narrows until it meets the "handle". The handle is comparatively thin, so that batters can comfortably grip the bat in their hands. Sometimes, especially on metal bats, the handle is wrapped with a rubber or tape "grip". Finally, below the handle is the "knob" of the bat, a wider piece that keeps the bat from slipping from a batter's hands.
Players can be very particular about their bats. Ted Williams cleaned his bats with alcohol every night and periodically took them to the post office to weigh them. "Bats pick up condensation and dirt lying around on the ground," he wrote, "They can gain an ounce or more in a surprisingly short time." Ichiro Suzuki also takes great care that his bats do not accumulate moisture and thus gain weight: he stores his bats in humidors, one in the club house and another, a portable one, for the road. Rod Carew fought moisture by storing his bats in a box full of sawdust in the warmest part of his house. "The sawdust acts as a buffer between the bats and the environment," he explained, "absorbing any moisture before it can seep into the wood."[25]
Fungo bats typically weigh between 17 to 22 ounces and may be as long as 37 inches, making them longer than most bats used for hitting. According to Pro Bats, a typical professional baseball player uses a bat that is about 34 inches long and weighs about 32 ounces, although there is considerable variation. Fungo bats not only are longer than regular bats, they also are skinnier. Like regular bats, fungo bats can be made of metal or wood.
Padded support shorts sometimes worn to protect the thighs when the player slides into the bases. Some sliding shorts contain a pocket for a protective cup. This is so the player does not have to wear a jockstrap and sliding shorts at the same time, although many players find the cup is held in place better by wearing it in a jockstrap under sliding shorts.
As to who created the first ever fungo, baseball fans may never know. The word fungoes and fungo batting have been referenced since the early 1800's, but nobody has been able to pinpoint the original source. Baseball fans and historians both agree that the creator of the first ever fungo is somewhat of a mystery. Here at JustBats, we may not know who created the first ever fungo, but we are sure glad that they did!
Helmet worn by batter to protect the head and the ear facing the pitcher from the ball. Professional models have only one ear protector (left ear for right-handed batters, right ear for lefties), amateur and junior helmets usually have ear protectors on both sides, for better protection from loose balls, and to reduce costs to teams (all players can use the same style of helmet).
Players can also create complex holes such as ‘two-part holes’ where the players must hit or reach one object before attempting to shoot at the hole. For example, a ‘two-part hole’ could consist of hitting the scoreboard first, and then once they have hit the scoreboard they must hit the ball back to home plate, that would be one hole with the player with the fewest strokes winning the hole. ‘Two-part holes’ are typically saved for the last hole in order to make things more complex and difficult on the leader.
×