At bat Baltimore chop Bat flip Chinese home run Batting count Bunt sacrifice bunt slap bunt squeeze play Checked swing Cleanup hitter Designated hitter Double Double switch Foul ball Foul tip Golden sombrero Grand slam Ground rule double Hat trick Hit Hit and run Hit by pitch Hitting for the cycle Home run Infield hit Inside-the-park home run Leadoff hitter Lefty-righty switch Line drive Moonshot Plate appearance Platoon system Pull hitter Sacrifice fly Single Strikeout Strike zone Sweet spot Switch hitter Triple Walk Walk-off home run
As to who created the first ever fungo, baseball fans may never know. The word fungoes and fungo batting have been referenced since the early 1800's, but nobody has been able to pinpoint the original source. Baseball fans and historians both agree that the creator of the first ever fungo is somewhat of a mystery. Here at JustBats, we may not know who created the first ever fungo, but we are sure glad that they did!
Maple bats in particular were once known (circa 2008) to potentially shatter in a way that resulted in many sharp edges, sometimes creating more dangerous projectiles when a bat broke.[9][13] Maple bat manufacture evolved significantly, in cooperation with Major League Baseball,[11] paying special attention to grain slope, and including an ink spot test to confirm safest wood grain orientation.[11]
Break your team up into 2 or 3 teams. If you do 2 teams you’ll need 8 or 9 on a team with a player for each defensive position. If you only have 8 on a team you can eliminate either the pitcher, catcher, or one outfielder based on what is a priority for your team that day.  If  you only have 12-15 players on your team break it up into 3 teams of 4-5. Then place two of the teams on defense and one team hitting fungoes. No matter what, have the teams and batting orders pre-made before practice. This will eliminate unnecessary downtime during practice.
Once in a while, veteran managers revive it. The Giants took infield occasionally in 2008 and 2013 under Bruce Bochy, and Jim Leyland instituted infield drills before batting practice late in his tenure in Detroit. Molitor, for one, misses it. He took infield even as a designated hitter late in his career because he hated sitting around for almost two hours waiting to play.
Manufacturers position each bat's label over the mechanically weaker side of the wood.[9] To reduce chance of fracture,[9] and maybe deliver more energy to the ball,[10] a bat is intended to be held so the label faces sky or ground when it strikes the ball during a horizontal swing.[9] In this orientation, the bat is considered stiffer and less likely to break.[11]
Baseball bats are made of either wood, or a metal alloy (typically aluminum). Most wooden bats are made from ash. Other woods include maple, hickory, and bamboo. Hickory has fallen into disfavor over its greater weight, which slows down bat speed, while maple bats gained popularity[5] following the introduction of the first major league sanctioned model in 1997. The first player to use one was Joe Carter of the Toronto Blue Jays.[6] Barry Bonds used maple bats the seasons he broke baseball's single-season home run record in 2001, and the career home run record in 2007.[6] In 2010, the increased tendency of maple bats to shatter has caused Major League Baseball to examine their use, banning some models in minor league play.[7][8]
The right baseball equipment can help players pitch, hit, field, and run to the best of their abilities. Whether you’re a coach or a proud parent of an aspiring baseball player, you have come to the right place. Anthem Sports is the most reliable source for coaches, athletic directors, and physical educators that want to set their students and players up for success by investing in the best equipment.
How the bat is made is what differentiates it from the typical regulation bat used by major league players. In addition to being lighter and thinner, the bat is also much longer compared to the normal bat. It ranges between 35 – 37 inches in terms of length. In terms of weight, the bat weighs between 17 – 22 ounces. Of great importance to note is the fact that the bat features a bigger barrel than the normal ones. Since it’s flatter and features a small diameter, it’s ideal when it comes to hitting ground balls as well as pop flies. This would be necessary during the fielding practice of any team regardless of the level.
In 1990, Bruce Leinert came up with the idea of putting an axe handle on a baseball bat. He filed a patent application for the 'Axe Bat' in 2007 and the bat started being used in the college and pro ranks over the following years. In 2012, the Marietta College Pioneers baseball team won the NCAA Division III World Series using axe handled bats.[2] Several Major League Baseball players have adopted the bat handle including Mookie Betts, Dustin Pedroia, George Springer, Kurt Suzuki and Dansby Swanson.[3][4]
Do this for about three minutes, then collect the balls and work on 5-3, 6-4, and 4-6 plays for another three minutes. This is followed by hitting balls to the 5-6 hole. If the third baseman doesn’t get it, he retreats back to third, and the shortstop flips to third for a force-out, rather than throwing across or turn a long double play. The other fungo batter hits balls to the second baseman, who works on throwing to first.
There are limitations to how much and where a baseball player may apply pine tar to a baseball bat. According to Rule 1.10(c) of the Major League Baseball Rulebook, it is not allowed more than 18 inches up from the bottom handle. An infamous example of the rule in execution is the Pine Tar Incident on July 24, 1983. Rules 1.10 and 6.06 were later changed to reflect the intent of Major League Baseball, as exemplified by the league president's ruling. Rule 1.10 now only requires that the bat be removed from the game if discovered after being used in a game; it no longer necessitates any change to the results of any play which may have taken place. Rule 6.06 refers only to bats that are "altered or tampered with in such a way to improve the distance factor or cause an unusual reaction on the baseball. This includes, bats that are filled, flat-surfaced, nailed, hollowed, grooved or covered with a substance such as paraffin, wax, etc." It no longer makes any mention of an "illegally batted ball". In 2001, MLB approved the use of Gorilla Gold Grip Enhancer in major and minor league games as an alternative to pine tar.[23][24]
Players can be very particular about their bats. Ted Williams cleaned his bats with alcohol every night and periodically took them to the post office to weigh them. "Bats pick up condensation and dirt lying around on the ground," he wrote, "They can gain an ounce or more in a surprisingly short time." Ichiro Suzuki also takes great care that his bats do not accumulate moisture and thus gain weight: he stores his bats in humidors, one in the club house and another, a portable one, for the road. Rod Carew fought moisture by storing his bats in a box full of sawdust in the warmest part of his house. "The sawdust acts as a buffer between the bats and the environment," he explained, "absorbing any moisture before it can seep into the wood."[25]
This sounds like a lot of information, but with a little practise on the coaches part, it runs quite smoothly. Two to three reps per player in the field per section is quite adequate, and with 14 men on the field, this whole routine should take about 7 minutes. It's quite snappy, and quite impressive. I had many a parent marvel to me after witnessing it - "you look like a professional team!" I wouldn't try the routine with anything less than a 14 yr old select team, but with the talent to do it right, it's fantastic.
A baseball bat is divided into several regions. The "barrel" is the thick part of the bat, where it is meant to hit the ball. The part of the barrel best for hitting the ball, according to construction and swinging style, is often called the "sweet spot". The end of the barrel is called the "top", "end" or "cap" of the bat. Opposite the cap, the barrel narrows until it meets the "handle". The handle is comparatively thin, so that batters can comfortably grip the bat in their hands. Sometimes, especially on metal bats, the handle is wrapped with a rubber or tape "grip". Finally, below the handle is the "knob" of the bat, a wider piece that keeps the bat from slipping from a batter's hands.
No, we're not talking about The Masters. We're talking about fungo golf, baseball's wonderful adaptation of frisbee golf. For those of you unfamiliar with the rules, the general goal is to hit predetermined objects or other landmarks located somewhere on a baseball field with a ball. Instead of a golf club, you use a fungo bat. All normal scoring rules of golf still apply.
Before we get started, we have to define the word "fungo" or "fungoes." To summarize, fungo (fungoes for plural) is a ball tossed into the air by the batter and struck as it comes down during practice sessions.  If you are a coach, you are more than likely familiar with a fungo bat. Or, if you are a player who has ever worked on ground balls or pop-flys in practice, you should know what a fungo bat is, as well. For the rest of us, a fungo bat might as well be a foreign object. What is that oddly shaped, extra long practice bat? So, let's answer the most common fungo bat questions:
×