The most obvious reasons to utilize a fungo bat is the fact that it’s lightweight. It’s handy to coaches when conducting fielding practice since he or she has to hit plenty of balls to warm up his or her players. What is for sure is that hitting countless balls during practice can be tiring. Consequently, having a bat that’s lighter weight is magical at preventing the coach and/or players from getting tired.
The bat's form has become more refined over time. In the mid-19th century, baseball batters were known to shape or whittle their own bats by hand. This allowed there to be a wide variety in shape, size, and weight. For example, there were flat bats, round bats, short bats, and fat bats. Earlier bats were known to be much heavier and larger than today's regulated ones. During the 19th century, many shapes were experimented with, as well as handle designs. Today, bats are much more uniform in design.
There are limitations to how much and where a baseball player may apply pine tar to a baseball bat. According to Rule 1.10(c) of the Major League Baseball Rulebook, it is not allowed more than 18 inches up from the bottom handle. An infamous example of the rule in execution is the Pine Tar Incident on July 24, 1983. Rules 1.10 and 6.06 were later changed to reflect the intent of Major League Baseball, as exemplified by the league president's ruling. Rule 1.10 now only requires that the bat be removed from the game if discovered after being used in a game; it no longer necessitates any change to the results of any play which may have taken place. Rule 6.06 refers only to bats that are "altered or tampered with in such a way to improve the distance factor or cause an unusual reaction on the baseball. This includes, bats that are filled, flat-surfaced, nailed, hollowed, grooved or covered with a substance such as paraffin, wax, etc." It no longer makes any mention of an "illegally batted ball". In 2001, MLB approved the use of Gorilla Gold Grip Enhancer in major and minor league games as an alternative to pine tar.[23][24]
Fungo bats have been around since the beginning of baseball and as most of us may know, baseball was said to be invented by Abner Doubleday in Cooperstown, New York during the summer of 1839. Since fungo bats were much easier to swing and gave off a ton of pop, they were almost seen as cheating back in the day. In a book from 1897 named "The Technical Terms of Baseball," the sportswriter Henry Chadwick stated,"The weakest batting is shown when the batsman indulges in fungo hitting." It wasn't until baseball bat regulations came around that fungo bats were only used by coaches and parents. 
This is the drill we ran all through high school. It is the most time effective and skill intensive way to warm up a team, but your boys must be able to play catch! Fungo-ers stand in the "fungoe circles" that any good field has (and if it doesn't, you know where they're supposed to be - just outside of the home-plate dirt circle, towards the dugouts). The catch to this method is this - you have two first basemen, allowing both sides of the infield to throw across. Herein lies the only danger - one of the firstbasemen has a lengthy throw back to a shagger, so caution must be excersized (a catcher with a good head on his shoulders really helps).

A baseball bat is a smooth wooden or metal club used in the sport of baseball to hit the ball after it is thrown by the pitcher. By regulation it may be no more than 2.75 inches (70 mm) in diameter at the thickest part and no more than 42 inches (1,100 mm) long. Although historically bats approaching 3 pounds (1.4 kg) were swung,[1] today bats of 33 ounces (0.94 kg) are common, topping out at 34 ounces (0.96 kg) to 36 ounces (1.0 kg).[1]
On June 17, 1890, Emile Kinst patented the ball-bat, or banana bat. The bat is shaped with a curve, hence the name banana bat. The creator of the bat, Kinst wrote: "The object of my invention is to provide a ball-bat which shall produce a rotary or spinning motion of the ball in its flight to a higher degree than is possible with any present known form of ball-bat, and thus to make it more difficult to catch the ball, or if caught, to hold it, and thus further to modify the conditions of the game".
Break your team up into 2 or 3 teams. If you do 2 teams you’ll need 8 or 9 on a team with a player for each defensive position. If you only have 8 on a team you can eliminate either the pitcher, catcher, or one outfielder based on what is a priority for your team that day.  If  you only have 12-15 players on your team break it up into 3 teams of 4-5. Then place two of the teams on defense and one team hitting fungoes. No matter what, have the teams and batting orders pre-made before practice. This will eliminate unnecessary downtime during practice.

On June 17, 1890, Emile Kinst patented the ball-bat, or banana bat. The bat is shaped with a curve, hence the name banana bat. The creator of the bat, Kinst wrote: "The object of my invention is to provide a ball-bat which shall produce a rotary or spinning motion of the ball in its flight to a higher degree than is possible with any present known form of ball-bat, and thus to make it more difficult to catch the ball, or if caught, to hold it, and thus further to modify the conditions of the game".


As I had previously mentioned, the amount of teaching points is limitless.  The length of the game will really depend on how often you stop the action in order to discuss points related to base running, backing up throws, fielding techniques, and etc.  If you have assistant coaches, have them distributed throughout the field in order to help with certain teaching points on the spot, thus eliminating full stoppages of the game.  Now get out there and start putting the “FUN” back into fungo. I know that’s pretty corny, but I couldn’t help myself 🙂
“They’re not moving, their feet are apart, their gloves are on the ground, backs are flat, and they’re working down to up, out to in, basically a steady roll back and forth probably 15 to 20 each,” Bates said. “Then they’ll turn their body, work glove side for another 15 to 20, and backhand 15 to 20. No movement, really, just making sure we’re watching the ball roll into our glove, fielding it, and doing all the things fundamentally correct.”
Padded support shorts sometimes worn to protect the thighs when the player slides into the bases. Some sliding shorts contain a pocket for a protective cup. This is so the player does not have to wear a jockstrap and sliding shorts at the same time, although many players find the cup is held in place better by wearing it in a jockstrap under sliding shorts.

The Wright & Ditsons Lajoie baseball bat. This bat had a normal size barrel but had two knobs on the handle. The lowest knob was at the bottom of the handle and the other knob was roughly two inches above the lowest knob. This was designed to have better spacing between the hands due to the knob being in the middle of the grip. This also gave batters an advantage when they choked up on the bat, because the second knob provided a better grip.


A baseball bat is a smooth wooden or metal club used in the sport of baseball to hit the ball after it is thrown by the pitcher. By regulation it may be no more than 2.75 inches (70 mm) in diameter at the thickest part and no more than 42 inches (1,100 mm) long. Although historically bats approaching 3 pounds (1.4 kg) were swung,[1] today bats of 33 ounces (0.94 kg) are common, topping out at 34 ounces (0.96 kg) to 36 ounces (1.0 kg).[1]
A fungo bat's size and weight make it easier to operate with one hand or two. Coaches can toss a ball up with one hand and hit pop flies or ground balls farther and with greater accuracy with a fungo bat than with a regular bat. According to an article by LJWorld, high school baseball coach Brad Stoll said fungo bats allow him to hit more balls because heavier regular bats would "wear you out." Fungo bats should be used as a practice tool only and should not be used to hit a pitched ball.
Manufacturers position each bat's label over the mechanically weaker side of the wood.[9] To reduce chance of fracture,[9] and maybe deliver more energy to the ball,[10] a bat is intended to be held so the label faces sky or ground when it strikes the ball during a horizontal swing.[9] In this orientation, the bat is considered stiffer and less likely to break.[11]
When it comes to baseball gloves, it's not uncommon for players to develop a deep attachment to their glove. It's the same glove they trot out onto the field with every inning and many players, once they are into the 'adult' sizes, use the same glove for their entire life! It might seem crazy to outsiders, but there's just something about a high quality, leather baseball glove that becomes part of a player to the point that it feels wrong to wear a different glove. That is why it is so important to find the right glove, the right pocket, the right size, the right leather, and the right color. Gloves aren't just gloves, they are part of who you become as a player. Check out our selection of gloves by position, size, and brand or explore the buying guide specifically made to help you decide which baseball glove to buy if you need some guidance!
A rounded, solid wooden or hollow aluminum bat. Wooden bats are traditionally made from ash wood, though maple and bamboo is also sometimes used. Aluminum bats are not permitted in professional leagues, but are frequently used in amateur leagues. Composite bats are also available, essentially wooden bats with a metal rod inside. Bamboo bats are also becoming popular.
Within league standards there is ample latitude for individual variation, many batters settling on their own bat profile, or one used by a successful batter. Formerly, bats were hand-turned from a template with precise calibration points; today they are machine-turned to a fixed metal template. Historically significant templates may be kept in a bat manufacturers' vault; for example, Babe Ruth's template, which became popular among major-league players, is R43 in the Louisville Slugger archives.[citation needed]
Though entertaining enough, this play appears in its entirety as a small part of Sorrentino's magnum opus MULLIGAN STEW. You can read it as easily there as in this form. Plus you'll have the rest of Mulligan Stew as well. So I recommend you only buy this volume if you're the sort of collector who owns books because of what they are, not what they say.
Once the basic bat has been turned, it has the manufacturer's name, the serial number, and often the signature of the player endorsing it branded into it opposite the wood's best side. Honus Wagner was the first player to endorse and sign a bat. Next, most bats are given a rounded head, but some 30%[citation needed] of players prefer a "cup-balanced" head, in which a cup-shaped recess is made in the head; this lightens the bat and moves its center of gravity toward the handle. Finally, the bat is stained in one of several standard colors, including natural, red, black, and two-tone blue and white.

Within league standards there is ample latitude for individual variation, many batters settling on their own bat profile, or one used by a successful batter. Formerly, bats were hand-turned from a template with precise calibration points; today they are machine-turned to a fixed metal template. Historically significant templates may be kept in a bat manufacturers' vault; for example, Babe Ruth's template, which became popular among major-league players, is R43 in the Louisville Slugger archives.[citation needed]
Within league standards there is ample latitude for individual variation, many batters settling on their own bat profile, or one used by a successful batter. Formerly, bats were hand-turned from a template with precise calibration points; today they are machine-turned to a fixed metal template. Historically significant templates may be kept in a bat manufacturers' vault; for example, Babe Ruth's template, which became popular among major-league players, is R43 in the Louisville Slugger archives.[citation needed]
Fungo bats have been around since the beginning of baseball and as most of us may know, baseball was said to be invented by Abner Doubleday in Cooperstown, New York during the summer of 1839. Since fungo bats were much easier to swing and gave off a ton of pop, they were almost seen as cheating back in the day. In a book from 1897 named "The Technical Terms of Baseball," the sportswriter Henry Chadwick stated,"The weakest batting is shown when the batsman indulges in fungo hitting." It wasn't until baseball bat regulations came around that fungo bats were only used by coaches and parents. 
×