Fungo bats have been around since the beginning of baseball and as most of us may know, baseball was said to be invented by Abner Doubleday in Cooperstown, New York during the summer of 1839. Since fungo bats were much easier to swing and gave off a ton of pop, they were almost seen as cheating back in the day. In a book from 1897 named "The Technical Terms of Baseball," the sportswriter Henry Chadwick stated,"The weakest batting is shown when the batsman indulges in fungo hitting." It wasn't until baseball bat regulations came around that fungo bats were only used by coaches and parents. 
A baseball bat is divided into several regions. The "barrel" is the thick part of the bat, where it is meant to hit the ball. The part of the barrel best for hitting the ball, according to construction and swinging style, is often called the "sweet spot". The end of the barrel is called the "top", "end" or "cap" of the bat. Opposite the cap, the barrel narrows until it meets the "handle". The handle is comparatively thin, so that batters can comfortably grip the bat in their hands. Sometimes, especially on metal bats, the handle is wrapped with a rubber or tape "grip". Finally, below the handle is the "knob" of the bat, a wider piece that keeps the bat from slipping from a batter's hands.
Next, the third base fungo hits to left, who come home, third baseman cuts (again, 60' from home, about the pitchers mound). First base fungo hits to right, who throw again to second (this is where we practised cutting off doubles on balls hit into the right field corner - it's really practiseing hitting your cutoff man quickly than anything else - also the reason it's safe to do while left field goes home).

If your high school or travel team has at least two coaches, you can use what Bates calls a two-fungo drill. One coach can hit to third and second, while the other hits to short and first. If catchers are finished working with the pitchers, they can feed balls to the fungo hitters. The idea is for the third baseman to practice turning a 5-4-3, with the first baseman moving up toward second base about 60 feet instead of 90, with a net behind him to catch overthrows. The shortstop works on throwing across on 6-3s.


Baseball bats are made of either wood, or a metal alloy (typically aluminum). Most wooden bats are made from ash. Other woods include maple, hickory, and bamboo. Hickory has fallen into disfavor over its greater weight, which slows down bat speed, while maple bats gained popularity[5] following the introduction of the first major league sanctioned model in 1997. The first player to use one was Joe Carter of the Toronto Blue Jays.[6] Barry Bonds used maple bats the seasons he broke baseball's single-season home run record in 2001, and the career home run record in 2007.[6] In 2010, the increased tendency of maple bats to shatter has caused Major League Baseball to examine their use, banning some models in minor league play.[7][8]
Fungo bats are, simply put, a long, skinny, and lightweight baseball bat used for fielding practice. Typically, they are around 34 to 37 inches in length and between 17 and 24 ounces in weight, give or take a couple of ounces. They will also almost always feature a 2 1/4 inch barrel diameter to allow for more control during a swing. As you can tell, fungo bats are longer than a normal baseball bat and much more lightweight in comparison. Most fungo bats are going to be made up of ash wood while there are some maple and bamboo wood fungo bats, some composite wood fungo bats, and very few aluminum alloy fungo bats. Almost all of these designs will be under $100 with very few eclipsing that mark. 
For starters, we should clarify just what we’re talking about when we say fungo bat. Longer, lighter and thinner than a regulation bat (but a larger barrel), a fungo bat is typically 35 to 37 inches long, and weighs between 17 and 22 ounces. As David Allison wrote in the June 1978 edition of Country Journal, “A fungo bat looks to be a cross between a baseball bat and a broomstick.”
×