Baseball bats are made of either wood, or a metal alloy (typically aluminum). Most wooden bats are made from ash. Other woods include maple, hickory, and bamboo. Hickory has fallen into disfavor over its greater weight, which slows down bat speed, while maple bats gained popularity[5] following the introduction of the first major league sanctioned model in 1997. The first player to use one was Joe Carter of the Toronto Blue Jays.[6] Barry Bonds used maple bats the seasons he broke baseball's single-season home run record in 2001, and the career home run record in 2007.[6] In 2010, the increased tendency of maple bats to shatter has caused Major League Baseball to examine their use, banning some models in minor league play.[7][8]

Even without a 100-mile per hour fastball barreling toward you, safety is paramount. Our helmet selection offers a wide variety of sizes, shapes, and colors to choose from. We also offer catcher’s gear, knee pads for home plate umpires, and other products to alleviate fatigue or the risk of injury. Our baseball equipment selection includes excellent training aids, such as batting tees, batting cages, pop-up hitting systems, professional pitching rubbers, mounds, contact training balls, pocket radars, and more.
At bat Baltimore chop Bat flip Chinese home run Batting count Bunt sacrifice bunt slap bunt squeeze play Checked swing Cleanup hitter Designated hitter Double Double switch Foul ball Foul tip Golden sombrero Grand slam Ground rule double Hat trick Hit Hit and run Hit by pitch Hitting for the cycle Home run Infield hit Inside-the-park home run Leadoff hitter Lefty-righty switch Line drive Moonshot Plate appearance Platoon system Pull hitter Sacrifice fly Single Strikeout Strike zone Sweet spot Switch hitter Triple Walk Walk-off home run
Players can be very particular about their bats. Ted Williams cleaned his bats with alcohol every night and periodically took them to the post office to weigh them. "Bats pick up condensation and dirt lying around on the ground," he wrote, "They can gain an ounce or more in a surprisingly short time." Ichiro Suzuki also takes great care that his bats do not accumulate moisture and thus gain weight: he stores his bats in humidors, one in the club house and another, a portable one, for the road. Rod Carew fought moisture by storing his bats in a box full of sawdust in the warmest part of his house. "The sawdust acts as a buffer between the bats and the environment," he explained, "absorbing any moisture before it can seep into the wood."[25]
This sounds like a lot of information, but with a little practise on the coaches part, it runs quite smoothly. Two to three reps per player in the field per section is quite adequate, and with 14 men on the field, this whole routine should take about 7 minutes. It's quite snappy, and quite impressive. I had many a parent marvel to me after witnessing it - "you look like a professional team!" I wouldn't try the routine with anything less than a 14 yr old select team, but with the talent to do it right, it's fantastic.
Baseball bats are made of either wood, or a metal alloy (typically aluminum). Most wooden bats are made from ash. Other woods include maple, hickory, and bamboo. Hickory has fallen into disfavor over its greater weight, which slows down bat speed, while maple bats gained popularity[5] following the introduction of the first major league sanctioned model in 1997. The first player to use one was Joe Carter of the Toronto Blue Jays.[6] Barry Bonds used maple bats the seasons he broke baseball's single-season home run record in 2001, and the career home run record in 2007.[6] In 2010, the increased tendency of maple bats to shatter has caused Major League Baseball to examine their use, banning some models in minor league play.[7][8]
To figure out who shoots first, players usually throw or roll a baseball to a certain object (usually at close range) and whoever is closest shoots first. The first person then gets to choose the first hole and tees off. To tee off (and for most shots) players hit the ball like they were playing baseball, but depending on the distance from the hole the player may choose to ‘putt’ the ball instead of hitting it. To putt the ball, the player places the ball on the cup (the end of the fungo bat), and can toss the ball from the cup in hopes of getting a more accurate shot.[1] In shooting or putting, the player must have one foot where the ball landed during the entire duration of their swing or putt, failure to keep the foot planted results in a loss of a stroke. Scorekeeping is identical to traditional golf; the player with the fewest strokes essentially wins the hole.[2] Players traditionally play nine or eighteen holes of fungo golf, and at the end the person with the fewest strokes in the set number of holes wins the game.[3]
×