Once the basic bat has been turned, it has the manufacturer's name, the serial number, and often the signature of the player endorsing it branded into it opposite the wood's best side. Honus Wagner was the first player to endorse and sign a bat. Next, most bats are given a rounded head, but some 30%[citation needed] of players prefer a "cup-balanced" head, in which a cup-shaped recess is made in the head; this lightens the bat and moves its center of gravity toward the handle. Finally, the bat is stained in one of several standard colors, including natural, red, black, and two-tone blue and white.
Fungo bats have been around since the beginning of baseball and as most of us may know, baseball was said to be invented by Abner Doubleday in Cooperstown, New York during the summer of 1839. Since fungo bats were much easier to swing and gave off a ton of pop, they were almost seen as cheating back in the day. In a book from 1897 named "The Technical Terms of Baseball," the sportswriter Henry Chadwick stated,"The weakest batting is shown when the batsman indulges in fungo hitting." It wasn't until baseball bat regulations came around that fungo bats were only used by coaches and parents. 
Fungo bats are typically only used by coaches, to consistently place grounders and pop flies to their fielders for practice purposes. And with a fungo bat in their hands, some coaches can pull off wicked accuracy – as one story goes, the late California Angels player and coach Jimmie Reese once shot an 82 on an 18-hole golf course using nothing but a putter and a fungo bat.
Play It Again Sports® is a registered trademark of Winmark Corporation based in Minneapolis, MN. Any unauthorized use of this trademark by others is subject to action under federal and state trademark laws. Other brand names are trademarked or registered by their respective companies. Each Play It Again Sports store is independently owned and operated.
To practice throwing around the infield, Bates recommends several drills you can use. The first involves placing four fielders in a square, about 15 feet apart. The players flip the ball underhanded to each other, like in a double play. Keep their arms straight, using a stiff wrist, with gloves on their hips once the ball is out. Every fielder follows their flip, glove side first, rotating around the square. The idea is to have a sequence of catch, flip and follow. The ball should be caught with two hands, palms open. After about two minutes, repeat the process rotating the other way for another two minutes.
Fungo bats are, simply put, a long, skinny, and lightweight baseball bat used for fielding practice. Typically, they are around 34 to 37 inches in length and between 17 and 24 ounces in weight, give or take a couple of ounces. They will also almost always feature a 2 1/4 inch barrel diameter to allow for more control during a swing. As you can tell, fungo bats are longer than a normal baseball bat and much more lightweight in comparison. Most fungo bats are going to be made up of ash wood while there are some maple and bamboo wood fungo bats, some composite wood fungo bats, and very few aluminum alloy fungo bats. Almost all of these designs will be under $100 with very few eclipsing that mark. 
A fungo bat's size and weight make it easier to operate with one hand or two. Coaches can toss a ball up with one hand and hit pop flies or ground balls farther and with greater accuracy with a fungo bat than with a regular bat. According to an article by LJWorld, high school baseball coach Brad Stoll said fungo bats allow him to hit more balls because heavier regular bats would "wear you out." Fungo bats should be used as a practice tool only and should not be used to hit a pitched ball.
Baseball bats are made of either wood, or a metal alloy (typically aluminum). Most wooden bats are made from ash. Other woods include maple, hickory, and bamboo. Hickory has fallen into disfavor over its greater weight, which slows down bat speed, while maple bats gained popularity[5] following the introduction of the first major league sanctioned model in 1997. The first player to use one was Joe Carter of the Toronto Blue Jays.[6] Barry Bonds used maple bats the seasons he broke baseball's single-season home run record in 2001, and the career home run record in 2007.[6] In 2010, the increased tendency of maple bats to shatter has caused Major League Baseball to examine their use, banning some models in minor league play.[7][8]
At bat Baltimore chop Bat flip Chinese home run Batting count Bunt sacrifice bunt slap bunt squeeze play Checked swing Cleanup hitter Designated hitter Double Double switch Foul ball Foul tip Golden sombrero Grand slam Ground rule double Hat trick Hit Hit and run Hit by pitch Hitting for the cycle Home run Infield hit Inside-the-park home run Leadoff hitter Lefty-righty switch Line drive Moonshot Plate appearance Platoon system Pull hitter Sacrifice fly Single Strikeout Strike zone Sweet spot Switch hitter Triple Walk Walk-off home run
Another variation of playing is setting a target (i.e. home plate), and that is the hole for the entire game. For the entire game players go to a different part of the field and try to hit home plate in the fewest strokes.To make the game more interesting players can create certain hazards or obstacles that the players must avoid hitting while making their shot. If a player hits a certain hazard then they may be penalized one stroke, a player can also lose a stroke if he loses their ball while taking a shot.
×