Manufacturers position each bat's label over the mechanically weaker side of the wood.[9] To reduce chance of fracture,[9] and maybe deliver more energy to the ball,[10] a bat is intended to be held so the label faces sky or ground when it strikes the ball during a horizontal swing.[9] In this orientation, the bat is considered stiffer and less likely to break.[11]
Players can be very particular about their bats. Ted Williams cleaned his bats with alcohol every night and periodically took them to the post office to weigh them. "Bats pick up condensation and dirt lying around on the ground," he wrote, "They can gain an ounce or more in a surprisingly short time." Ichiro Suzuki also takes great care that his bats do not accumulate moisture and thus gain weight: he stores his bats in humidors, one in the club house and another, a portable one, for the road. Rod Carew fought moisture by storing his bats in a box full of sawdust in the warmest part of his house. "The sawdust acts as a buffer between the bats and the environment," he explained, "absorbing any moisture before it can seep into the wood."[25]
The fungo is used by a coach to hit balls for defense practice. It is lighter weight, so less fatiguing to hit ball after ball. The fungo sheds its weight above the hands. The severely tapered barrel to drops weight and maintains a high moment of inertia. While the bat would be at greater risk of breaking if used in a live batting exercise, it is safe to use in practice because there are much fewer mis-hits.

The Wright & Ditsons Lajoie baseball bat. This bat had a normal size barrel but had two knobs on the handle. The lowest knob was at the bottom of the handle and the other knob was roughly two inches above the lowest knob. This was designed to have better spacing between the hands due to the knob being in the middle of the grip. This also gave batters an advantage when they choked up on the bat, because the second knob provided a better grip.
Many players "bone" their bats, meaning that before games, they rub their bats repeatedly with a hard object, believing this closes the pores on the wood and hardens the bat. Animal bones are a popular boning material, but rolling pins, soda bottles and the edge of a porcelain sink have also been used. Pete Rose had his own way of hardening his bats: he soaked them in a tub of motor oil in his basement then hung them up to dry.[25]
A fungo bat's size and weight make it easier to operate with one hand or two. Coaches can toss a ball up with one hand and hit pop flies or ground balls farther and with greater accuracy with a fungo bat than with a regular bat. According to an article by LJWorld, high school baseball coach Brad Stoll said fungo bats allow him to hit more balls because heavier regular bats would "wear you out." Fungo bats should be used as a practice tool only and should not be used to hit a pitched ball.

To figure out who shoots first, players usually throw or roll a baseball to a certain object (usually at close range) and whoever is closest shoots first. The first person then gets to choose the first hole and tees off. To tee off (and for most shots) players hit the ball like they were playing baseball, but depending on the distance from the hole the player may choose to ‘putt’ the ball instead of hitting it. To putt the ball, the player places the ball on the cup (the end of the fungo bat), and can toss the ball from the cup in hopes of getting a more accurate shot.[1] In shooting or putting, the player must have one foot where the ball landed during the entire duration of their swing or putt, failure to keep the foot planted results in a loss of a stroke. Scorekeeping is identical to traditional golf; the player with the fewest strokes essentially wins the hole.[2] Players traditionally play nine or eighteen holes of fungo golf, and at the end the person with the fewest strokes in the set number of holes wins the game.[3]
×