also called jock or athletic supporter. An undergarment worn by boys and men for support of the testicles and penis during sports. A jockstrap by itself holds the testicles up and close to the body to help keep them from being squished between the thighs, or from twisting or hangingout. The jockstrap with cup pocket contains a pocket to hold a protective cup.
The most obvious reasons to utilize a fungo bat is the fact that it’s lightweight. It’s handy to coaches when conducting fielding practice since he or she has to hit plenty of balls to warm up his or her players. What is for sure is that hitting countless balls during practice can be tiring. Consequently, having a bat that’s lighter weight is magical at preventing the coach and/or players from getting tired.
There are many advantages to using a fungo bat. If you are a coach or a parent looking to improve your player's defensive skill set, you're going to want and need a fungo bat. A normal adult wooden baseball bat will weigh around 27-31 ounces, and after a couple of rounds of pop-flys, it is going to feel like you just went through a full-on workout. With the help of a fungo bat, you will be able to hit ground balls and pop flys all day without getting fatigued.  The barrel on a fungo bat will typically be 2 1/4 inches in diameter which greatly helps increase your control over the bat through the hitting zone. While the barrel has a much more thin diameter, it is also much longer in comparison to a normal wood baseball bat. This larger hitting surface and smaller barrel combine to give coaches and parents quick swing speeds with precise accuracy. 
How the bat is made is what differentiates it from the typical regulation bat used by major league players. In addition to being lighter and thinner, the bat is also much longer compared to the normal bat. It ranges between 35 – 37 inches in terms of length. In terms of weight, the bat weighs between 17 – 22 ounces. Of great importance to note is the fact that the bat features a bigger barrel than the normal ones. Since it’s flatter and features a small diameter, it’s ideal when it comes to hitting ground balls as well as pop flies. This would be necessary during the fielding practice of any team regardless of the level.
Next, third base fungo hits to left, who throw to second, SS cuts (make a few of these the "cut off a double on a ball hit into the corner" variety - timing becomes important here, as the other fungo needs to hit many fewer balls than the fungo hitting to left). First base fungo hits to right, who come home, first baseman is cutoff, 60' from home (about pitchers mound - this postitioning puts him out of harms way should the SS overthrow second). On the throws home from right, make sure that they are the "normal" kind - hit the cutoff man, and don't hit too many. The right fielders will get to go again, as they're last throws will be the "do-or die" variety.

Play It Again Sports® is a registered trademark of Winmark Corporation based in Minneapolis, MN. Any unauthorized use of this trademark by others is subject to action under federal and state trademark laws. Other brand names are trademarked or registered by their respective companies. Each Play It Again Sports store is independently owned and operated.

Getting ready to gear up for another season at the ballpark? Looking for the very best in on-field equipment and apparel? Or maybe you’re a coach looking to strengthen your team’s skills with brand new baseball training equipment? Modell’s is here to help you hit this next season out of the park with a huge selection of baseball equipment that will have you or your players feeling like the big leagues and performing at their peak. Of course, you can’t run out on the field without first having the right apparel for the job! From head to toe, cleats to socks to pants to gloves and above, Modell’s has the perfect baseball equipment. Especially in the scorching summer months of the baseball season, having a lightweight, breathable pant is a must to make it through the game. Shop the top baseball pant brands in Rawlings, Nike and Under Armour directly from the Modell’s site and save some yourself some sweat and money. We also carry top-of-the-line, stylish yet fully functional cleats and socks to keep your feet moving around the bases. We stock cleats and socks in our baseball equipment catalog for children all the way up through adult sizes, from iconic brands like adidas, New Balance, Under Armour, Rawlings and so many more to choose from! Of course, a ballplayer is nothing without his or her bat and glove. We carry a massive variety of bats in our baseball equipment inventory to choose from, including natural ash wood bats, t-ball bats, aluminum alloy and player replica bats so you can find the ideal piece of baseball equipment to meet your needs. We stock gloves for every position and both hands, including catcher mitts, so whether you’re guarding the plate or roaming the outfield, you can be ready to make that next awe-inspiring catch.

Both wooden and metal alloy (generally aluminum) bats are generally permitted in amateur baseball. Metal alloy bats are generally regarded as being capable of hitting a ball faster and farther with the same power. However, increasing numbers of "wooden bat leagues" have emerged in recent years, reflecting a trend back to wood over safety concerns and, in the case of collegiate summer baseball wood-bat leagues, to better prepare players for the professional leagues that require wood bats. Metal alloy bats can send a ball towards an unprotected pitcher's head up to 60 ft 6 in (18.44 m) away at a velocity far too high for the pitcher to get out of the way in time. Some amateur baseball organizations enforce bat manufacturing and testing standards which attempt to limit maximum ball speed for wood and non-wood bats.[17][18][19]
To practice throwing around the infield, Bates recommends several drills you can use. The first involves placing four fielders in a square, about 15 feet apart. The players flip the ball underhanded to each other, like in a double play. Keep their arms straight, using a stiff wrist, with gloves on their hips once the ball is out. Every fielder follows their flip, glove side first, rotating around the square. The idea is to have a sequence of catch, flip and follow. The ball should be caught with two hands, palms open. After about two minutes, repeat the process rotating the other way for another two minutes.
Maple bats in particular were once known (circa 2008) to potentially shatter in a way that resulted in many sharp edges, sometimes creating more dangerous projectiles when a bat broke.[9][13] Maple bat manufacture evolved significantly, in cooperation with Major League Baseball,[11] paying special attention to grain slope, and including an ink spot test to confirm safest wood grain orientation.[11]
How the bat is made is what differentiates it from the typical regulation bat used by major league players. In addition to being lighter and thinner, the bat is also much longer compared to the normal bat. It ranges between 35 – 37 inches in terms of length. In terms of weight, the bat weighs between 17 – 22 ounces. Of great importance to note is the fact that the bat features a bigger barrel than the normal ones. Since it’s flatter and features a small diameter, it’s ideal when it comes to hitting ground balls as well as pop flies. This would be necessary during the fielding practice of any team regardless of the level.
Players can be very particular about their bats. Ted Williams cleaned his bats with alcohol every night and periodically took them to the post office to weigh them. "Bats pick up condensation and dirt lying around on the ground," he wrote, "They can gain an ounce or more in a surprisingly short time." Ichiro Suzuki also takes great care that his bats do not accumulate moisture and thus gain weight: he stores his bats in humidors, one in the club house and another, a portable one, for the road. Rod Carew fought moisture by storing his bats in a box full of sawdust in the warmest part of his house. "The sawdust acts as a buffer between the bats and the environment," he explained, "absorbing any moisture before it can seep into the wood."[25]
As I had previously mentioned, the amount of teaching points is limitless.  The length of the game will really depend on how often you stop the action in order to discuss points related to base running, backing up throws, fielding techniques, and etc.  If you have assistant coaches, have them distributed throughout the field in order to help with certain teaching points on the spot, thus eliminating full stoppages of the game.  Now get out there and start putting the “FUN” back into fungo. I know that’s pretty corny, but I couldn’t help myself 🙂
The Wright & Ditsons Lajoie baseball bat. This bat had a normal size barrel but had two knobs on the handle. The lowest knob was at the bottom of the handle and the other knob was roughly two inches above the lowest knob. This was designed to have better spacing between the hands due to the knob being in the middle of the grip. This also gave batters an advantage when they choked up on the bat, because the second knob provided a better grip.
Secondly, the first base fungo hits balls to the third baseman, who turns a double play with the second baseman to the normal first baseman, while the third base fungo hits balls to the shortstop, who throws to a shortened deep firstbaseman (this means that the deep firstbaseman stands closer to the shortstop than normal, so that the throw across this infield is the correct distance - this does NOT mean that the deep man stands any closer to the normal first base position - this length should always be sufficient)
Players can be very particular about their bats. Ted Williams cleaned his bats with alcohol every night and periodically took them to the post office to weigh them. "Bats pick up condensation and dirt lying around on the ground," he wrote, "They can gain an ounce or more in a surprisingly short time." Ichiro Suzuki also takes great care that his bats do not accumulate moisture and thus gain weight: he stores his bats in humidors, one in the club house and another, a portable one, for the road. Rod Carew fought moisture by storing his bats in a box full of sawdust in the warmest part of his house. "The sawdust acts as a buffer between the bats and the environment," he explained, "absorbing any moisture before it can seep into the wood."[25]
Fungo bats are, simply put, a long, skinny, and lightweight baseball bat used for fielding practice. Typically, they are around 34 to 37 inches in length and between 17 and 24 ounces in weight, give or take a couple of ounces. They will also almost always feature a 2 1/4 inch barrel diameter to allow for more control during a swing. As you can tell, fungo bats are longer than a normal baseball bat and much more lightweight in comparison. Most fungo bats are going to be made up of ash wood while there are some maple and bamboo wood fungo bats, some composite wood fungo bats, and very few aluminum alloy fungo bats. Almost all of these designs will be under $100 with very few eclipsing that mark. 
×