There are many advantages to using a fungo bat. If you are a coach or a parent looking to improve your player's defensive skill set, you're going to want and need a fungo bat. A normal adult wooden baseball bat will weigh around 27-31 ounces, and after a couple of rounds of pop-flys, it is going to feel like you just went through a full-on workout. With the help of a fungo bat, you will be able to hit ground balls and pop flys all day without getting fatigued.  The barrel on a fungo bat will typically be 2 1/4 inches in diameter which greatly helps increase your control over the bat through the hitting zone. While the barrel has a much more thin diameter, it is also much longer in comparison to a normal wood baseball bat. This larger hitting surface and smaller barrel combine to give coaches and parents quick swing speeds with precise accuracy. 
A fungo bat's size and weight make it easier to operate with one hand or two. Coaches can toss a ball up with one hand and hit pop flies or ground balls farther and with greater accuracy with a fungo bat than with a regular bat. According to an article by LJWorld, high school baseball coach Brad Stoll said fungo bats allow him to hit more balls because heavier regular bats would "wear you out." Fungo bats should be used as a practice tool only and should not be used to hit a pitched ball.
also called jock or athletic supporter. An undergarment worn by boys and men for support of the testicles and penis during sports. A jockstrap by itself holds the testicles up and close to the body to help keep them from being squished between the thighs, or from twisting or hangingout. The jockstrap with cup pocket contains a pocket to hold a protective cup.
The Wright & Ditsons Lajoie baseball bat. This bat had a normal size barrel but had two knobs on the handle. The lowest knob was at the bottom of the handle and the other knob was roughly two inches above the lowest knob. This was designed to have better spacing between the hands due to the knob being in the middle of the grip. This also gave batters an advantage when they choked up on the bat, because the second knob provided a better grip.
A baseball bat is divided into several regions. The "barrel" is the thick part of the bat, where it is meant to hit the ball. The part of the barrel best for hitting the ball, according to construction and swinging style, is often called the "sweet spot". The end of the barrel is called the "top", "end" or "cap" of the bat. Opposite the cap, the barrel narrows until it meets the "handle". The handle is comparatively thin, so that batters can comfortably grip the bat in their hands. Sometimes, especially on metal bats, the handle is wrapped with a rubber or tape "grip". Finally, below the handle is the "knob" of the bat, a wider piece that keeps the bat from slipping from a batter's hands.

Players can be very particular about their bats. Ted Williams cleaned his bats with alcohol every night and periodically took them to the post office to weigh them. "Bats pick up condensation and dirt lying around on the ground," he wrote, "They can gain an ounce or more in a surprisingly short time." Ichiro Suzuki also takes great care that his bats do not accumulate moisture and thus gain weight: he stores his bats in humidors, one in the club house and another, a portable one, for the road. Rod Carew fought moisture by storing his bats in a box full of sawdust in the warmest part of his house. "The sawdust acts as a buffer between the bats and the environment," he explained, "absorbing any moisture before it can seep into the wood."[25]
Both wooden and metal alloy (generally aluminum) bats are generally permitted in amateur baseball. Metal alloy bats are generally regarded as being capable of hitting a ball faster and farther with the same power. However, increasing numbers of "wooden bat leagues" have emerged in recent years, reflecting a trend back to wood over safety concerns and, in the case of collegiate summer baseball wood-bat leagues, to better prepare players for the professional leagues that require wood bats. Metal alloy bats can send a ball towards an unprotected pitcher's head up to 60 ft 6 in (18.44 m) away at a velocity far too high for the pitcher to get out of the way in time. Some amateur baseball organizations enforce bat manufacturing and testing standards which attempt to limit maximum ball speed for wood and non-wood bats.[17][18][19]
Players can also create complex holes such as ‘two-part holes’ where the players must hit or reach one object before attempting to shoot at the hole. For example, a ‘two-part hole’ could consist of hitting the scoreboard first, and then once they have hit the scoreboard they must hit the ball back to home plate, that would be one hole with the player with the fewest strokes winning the hole. ‘Two-part holes’ are typically saved for the last hole in order to make things more complex and difficult on the leader.
×