Secondly, the first base fungo hits balls to the third baseman, who turns a double play with the second baseman to the normal first baseman, while the third base fungo hits balls to the shortstop, who throws to a shortened deep firstbaseman (this means that the deep firstbaseman stands closer to the shortstop than normal, so that the throw across this infield is the correct distance - this does NOT mean that the deep man stands any closer to the normal first base position - this length should always be sufficient)
Do this for about three minutes, then collect the balls and work on 5-3, 6-4, and 4-6 plays for another three minutes. This is followed by hitting balls to the 5-6 hole. If the third baseman doesn’t get it, he retreats back to third, and the shortstop flips to third for a force-out, rather than throwing across or turn a long double play. The other fungo batter hits balls to the second baseman, who works on throwing to first.
A baseball bat is divided into several regions. The "barrel" is the thick part of the bat, where it is meant to hit the ball. The part of the barrel best for hitting the ball, according to construction and swinging style, is often called the "sweet spot". The end of the barrel is called the "top", "end" or "cap" of the bat. Opposite the cap, the barrel narrows until it meets the "handle". The handle is comparatively thin, so that batters can comfortably grip the bat in their hands. Sometimes, especially on metal bats, the handle is wrapped with a rubber or tape "grip". Finally, below the handle is the "knob" of the bat, a wider piece that keeps the bat from slipping from a batter's hands.
A fungo bat is a specially designed bat used by baseball and softball coaches for practice. The etymology of the word fungo ( /ˈfʌŋɡoʊ/) is uncertain, but the Oxford English Dictionary suggests it is derived from the Scots fung: to pitch, toss, or fling.[26] A fungo is longer and lighter than a regulation bat, with a smaller diameter. The bat is designed to hit balls tossed up in the air by the batter, not pitched balls.[27] Typical fungo bats are 35 to 37 inches (89 to 94 cm) long and weigh 17 to 22 ounces (480 to 620 g). Coaches hit many balls during fielding practice, and the weight and length allow the coach to hit balls repeatedly with high accuracy. The small diameter also allows coaches to easily hit pop-ups to catchers and infielders along with ground balls due to better control of the barrel of the bat.
They can either be wood or aluminum. I encourage you to use a wood one. If not, I will make fun of you like I do my good friend Bill Booker at LaSalle-Peru H.S. for using his aluminum one. If you choose the wood fungo, I would recommend taping the barrel.  If you hit a good number of fungoes, the tape will increase the durability of the bat. I took the tape off of one once. The barrell was like sawdust, but I re-taped it and it was ready to go.  One season, I figured it out, between the  high school, American Legion, an junior high seasons I had hit over 10,000 fungoes. Tape it up!
Fungo bats are, simply put, a long, skinny, and lightweight baseball bat used for fielding practice. Typically, they are around 34 to 37 inches in length and between 17 and 24 ounces in weight, give or take a couple of ounces. They will also almost always feature a 2 1/4 inch barrel diameter to allow for more control during a swing. As you can tell, fungo bats are longer than a normal baseball bat and much more lightweight in comparison. Most fungo bats are going to be made up of ash wood while there are some maple and bamboo wood fungo bats, some composite wood fungo bats, and very few aluminum alloy fungo bats. Almost all of these designs will be under $100 with very few eclipsing that mark. 
To practice throwing around the infield, Bates recommends several drills you can use. The first involves placing four fielders in a square, about 15 feet apart. The players flip the ball underhanded to each other, like in a double play. Keep their arms straight, using a stiff wrist, with gloves on their hips once the ball is out. Every fielder follows their flip, glove side first, rotating around the square. The idea is to have a sequence of catch, flip and follow. The ball should be caught with two hands, palms open. After about two minutes, repeat the process rotating the other way for another two minutes.

Baseball players spend more time training and practicing than playing actual games. You need equipment to take the field during a game, but that equipment won't necessarily prepare you to perform your best out there. Training aids and other baseball practice tools help to grow your game before you take the field so that when you do take that important swing, or field that liner your body and mind are prepared to perform. With batting aids, pitching aids, fielding aids, hitting tees, pitching machines, practice balls, and many more training equipment, Sports Unlimited is able to provide the opportunity to turn any baseball hopeful into a better baseball player. Dreaming it doesn't make it come true, but training hard might.
The main goal of the game is to hit it to the pin in the least amount of strokes, similar to golf. Holes can consist of a certain sign in the outfield, in the tarp tunnel, off of the foul pole, onto the pitchers mound or off of a yardage marker on the outfield wall; it can really be anything on the field that can be hit without breaking. There can even be 2 part holes such as: First you have to hit the ball off of the scoreboard, then you have to hit the ball off of the right field foul pole.
×