A fungo bat is a specially designed bat used by baseball and softball coaches for practice. The etymology of the word fungo ( /ˈfʌŋɡoʊ/) is uncertain, but the Oxford English Dictionary suggests it is derived from the Scots fung: to pitch, toss, or fling.[26] A fungo is longer and lighter than a regulation bat, with a smaller diameter. The bat is designed to hit balls tossed up in the air by the batter, not pitched balls.[27] Typical fungo bats are 35 to 37 inches (89 to 94 cm) long and weigh 17 to 22 ounces (480 to 620 g). Coaches hit many balls during fielding practice, and the weight and length allow the coach to hit balls repeatedly with high accuracy. The small diameter also allows coaches to easily hit pop-ups to catchers and infielders along with ground balls due to better control of the barrel of the bat.
A baseball bat is divided into several regions. The "barrel" is the thick part of the bat, where it is meant to hit the ball. The part of the barrel best for hitting the ball, according to construction and swinging style, is often called the "sweet spot". The end of the barrel is called the "top", "end" or "cap" of the bat. Opposite the cap, the barrel narrows until it meets the "handle". The handle is comparatively thin, so that batters can comfortably grip the bat in their hands. Sometimes, especially on metal bats, the handle is wrapped with a rubber or tape "grip". Finally, below the handle is the "knob" of the bat, a wider piece that keeps the bat from slipping from a batter's hands.
The bat's form has become more refined over time. In the mid-19th century, baseball batters were known to shape or whittle their own bats by hand. This allowed there to be a wide variety in shape, size, and weight. For example, there were flat bats, round bats, short bats, and fat bats. Earlier bats were known to be much heavier and larger than today's regulated ones. During the 19th century, many shapes were experimented with, as well as handle designs. Today, bats are much more uniform in design.

The most obvious reasons to utilize a fungo bat is the fact that it’s lightweight. It’s handy to coaches when conducting fielding practice since he or she has to hit plenty of balls to warm up his or her players. What is for sure is that hitting countless balls during practice can be tiring. Consequently, having a bat that’s lighter weight is magical at preventing the coach and/or players from getting tired.
A fungo bat is used by the coach to hit ground balls or fly balls to his team. All throughout high school and college many players use fungo bats to play fungo golf. This is when each person has a fungo bat and a baseball and they pick out targets around their field or complex and basically play it in the same manner as golf. Fungo bats should not be used to hit a pitched baseball because they are much weaker than normal bats and will break much much easier.

Fungo bats are, simply put, a long, skinny, and lightweight baseball bat used for fielding practice. Typically, they are around 34 to 37 inches in length and between 17 and 24 ounces in weight, give or take a couple of ounces. They will also almost always feature a 2 1/4 inch barrel diameter to allow for more control during a swing. As you can tell, fungo bats are longer than a normal baseball bat and much more lightweight in comparison. Most fungo bats are going to be made up of ash wood while there are some maple and bamboo wood fungo bats, some composite wood fungo bats, and very few aluminum alloy fungo bats. Almost all of these designs will be under $100 with very few eclipsing that mark. 
Do this for about three minutes, then collect the balls and work on 5-3, 6-4, and 4-6 plays for another three minutes. This is followed by hitting balls to the 5-6 hole. If the third baseman doesn’t get it, he retreats back to third, and the shortstop flips to third for a force-out, rather than throwing across or turn a long double play. The other fungo batter hits balls to the second baseman, who works on throwing to first.
Players can also create complex holes such as ‘two-part holes’ where the players must hit or reach one object before attempting to shoot at the hole. For example, a ‘two-part hole’ could consist of hitting the scoreboard first, and then once they have hit the scoreboard they must hit the ball back to home plate, that would be one hole with the player with the fewest strokes winning the hole. ‘Two-part holes’ are typically saved for the last hole in order to make things more complex and difficult on the leader.
×