As I had previously mentioned, the amount of teaching points is limitless. The length of the game will really depend on how often you stop the action in order to discuss points related to base running, backing up throws, fielding techniques, and etc. If you have assistant coaches, have them distributed throughout the field in order to help with certain teaching points on the spot, thus eliminating full stoppages of the game. Now get out there and start putting the “FUN” back into fungo. I know that’s pretty corny, but I couldn’t help myself 🙂
Maple bats in particular were once known (circa 2008) to potentially shatter in a way that resulted in many sharp edges, sometimes creating more dangerous projectiles when a bat broke. Maple bat manufacture evolved significantly, in cooperation with Major League Baseball, paying special attention to grain slope, and including an ink spot test to confirm safest wood grain orientation.
Baseball bats are made of either wood, or a metal alloy (typically aluminum). Most wooden bats are made from ash. Other woods include maple, hickory, and bamboo. Hickory has fallen into disfavor over its greater weight, which slows down bat speed, while maple bats gained popularity following the introduction of the first major league sanctioned model in 1997. The first player to use one was Joe Carter of the Toronto Blue Jays. Barry Bonds used maple bats the seasons he broke baseball's single-season home run record in 2001, and the career home run record in 2007. In 2010, the increased tendency of maple bats to shatter has caused Major League Baseball to examine their use, banning some models in minor league play.
Fungo bats are, simply put, a long, skinny, and lightweight baseball bat used for fielding practice. Typically, they are around 34 to 37 inches in length and between 17 and 24 ounces in weight, give or take a couple of ounces. They will also almost always feature a 2 1/4 inch barrel diameter to allow for more control during a swing. As you can tell, fungo bats are longer than a normal baseball bat and much more lightweight in comparison. Most fungo bats are going to be made up of ash wood while there are some maple and bamboo wood fungo bats, some composite wood fungo bats, and very few aluminum alloy fungo bats. Almost all of these designs will be under $100 with very few eclipsing that mark.
A baseball bat is divided into several regions. The "barrel" is the thick part of the bat, where it is meant to hit the ball. The part of the barrel best for hitting the ball, according to construction and swinging style, is often called the "sweet spot". The end of the barrel is called the "top", "end" or "cap" of the bat. Opposite the cap, the barrel narrows until it meets the "handle". The handle is comparatively thin, so that batters can comfortably grip the bat in their hands. Sometimes, especially on metal bats, the handle is wrapped with a rubber or tape "grip". Finally, below the handle is the "knob" of the bat, a wider piece that keeps the bat from slipping from a batter's hands.
If your high school or travel team has at least two coaches, you can use what Bates calls a two-fungo drill. One coach can hit to third and second, while the other hits to short and first. If catchers are finished working with the pitchers, they can feed balls to the fungo hitters. The idea is for the third baseman to practice turning a 5-4-3, with the first baseman moving up toward second base about 60 feet instead of 90, with a net behind him to catch overthrows. The shortstop works on throwing across on 6-3s.
Players can also create complex holes such as ‘two-part holes’ where the players must hit or reach one object before attempting to shoot at the hole. For example, a ‘two-part hole’ could consist of hitting the scoreboard first, and then once they have hit the scoreboard they must hit the ball back to home plate, that would be one hole with the player with the fewest strokes winning the hole. ‘Two-part holes’ are typically saved for the last hole in order to make things more complex and difficult on the leader.